Andrew manual ES45T-T Reflector Assembly Step

ES45T-T Reflector Assembly

Step 2

Step 3

Step 4

Step 5

Step 6

Step 7

Step 8

Step 9

Step 10

Loosely attach tee plates (P/N 202447) and corresponding rib connecting plates (P/N 202444) to points B, C, D, E, and F.

•Use A-325 ½ x 1-¼ in. bolts, flatwashers and nuts. (see page 12)

•Insert bolts from concave side of reflector

CAUTION: Do not install A-325 ½ x 1-¼ in. hardware in center hole of rib connecting plates (P/N 202444) at positions B, D, or F only.

Loosely assemble two support angles (P/N 49438) to pivot bracket (P/N 300758). Attach opposite ends of support angles to tee plates (P/N 202447) at points A and E.

•Angle should be installed with edge up and flat of angle toward reflector

Loosely attach support angle (P/N 49436) from tee plate at F to pivot bracket (P/N 300758).

•Angle should be installed edge down with flat of angle away from reflector

Loosely assemble two support angles (P/N 49438) to pivot bracket (P/N 300745). Attach opposite ends of support angles to tee plates (P/N 202447) at points A and C.

•Angles should be installed edge up with flat of angle toward reflector.

Loosely attach support angle (P/N 49436) between tee plate at point B and pivot brack- et (P/N 300745).

•Angle should be installed edge down with flat of angle away from reflector

Loosely attach support angle (P/N 49437) between pivot brackets (P/N 300745/300758).

•Angle should be installed edge down with flat of angle away from reflector

Loosely assemble support angles (P/N 49438) to elevation axis bracket (P/N 49429-2). Attach opposite ends of support angles to tee plates at points C and E.

•Angles should be installed edge up with flat of angle toward reflector

Loosely attach support angle (P/N 49436) between tee plate at point D and elevation axis bracket (P/N 49429-2).

•Angle should be installed edge down with flat of angle away from reflector

Loosely attach support angles (P/N 49437) between elevation axis bracket and the two pivot brackets.

•Angles should be installed edge down with flat side away from reflector

56 Installation Procedures