Andrew ES45T manual Line of Sight Steel Rule Elevation

ES45T-T Reflector Assembly

Step 2

Step 3

Step 4

Step 5

Step 6

Position theodolite, transit or laser level about 10 feet [3m] from outside perimeter of reflector (see Figure 62).

Line of Sight	Steel Rule
(0.0° Elevation)
	0.03-0.06 Inch	Pointed Measuring Rod
	Increment
		6’ (1.8 m)
	(0.5-1.0 mm)
		Reflector
Theodolite,
Transit or	Reflector
Laser Level		Diameter Setting Band
	Turn Back
Approx. 10 Feet (3 m)
Shim Stack - Not
Shown for Clarity		Temporary Support
		12 Inch (300 mm)

Figure 62

Level theodolite/transit/laser level. If using theodolite, position view scope at 0.0 degrees elevation, lock down elevation adjustment.

Site through theodolite/transit to determine where on measuring rod to place steel rule onto rod to allow visibility of steel rule through theodolite/transit/laser level at all (6) six measurement locations around reflector. Securely fasten both ends of steel rule to mea- suring rod with adhesive tape (see Figure 62).

Temporary supports should be positioned as shown in Figure 63, close to but not inter- fering with diameter setting bands.

Referring to Figure 63, mark the measuring location at each of the six temporary sup- port locations with a small dot (use felt tip marker) to be used as reference point in sub- sequent measurements.

Reflector

Turnback

Outside Edge
of Reflector
	Diameter Setting
	Band (Hidden)
Setting Band	Reflector Seam
Hardware (2)
Shim Stack	Seam Hardware Not Shown for Clarity
(as required)	Measurement Location
Temporary	Directly Above Shim Stack
Support

Figure 63

52 Installation Procedures