Andrew manual ES45T-T Reflector Assembly ES45T-T-1 Reflector Step

ES45T-T Reflector Assembly

ES45T-T-1 Reflector

Step 1

Step 2

The ES45T-T-1 reflector is composed of six precision-formed panels designed for accu- rate strength, and ensures a reliable surface contour that provides exceptional operating characteristics in C-, X- or Ku-frequency bands.

Reflector should be assembled on a clear, flat area in front of the foundation pad. Clear debris from area and place plastic sheeting from packing crate as shown in Figure 56.

Arrange diameter setting band assembly (P/N 49612) and temporary supports as shown in Figure 54.

•Tighten ¼-20 hardware at center connection until snug

•Reflector should be assembled in front of foundation pad with bottom of reflector 3 ft. from pad

•Temporary supports should be 6-8 in. high

•Tie three string levels to opposing blocks across diameter of circle

•Adjust supports with shims until strings are level and lightly touch at center of circle

•Once supports are level, remove strings

•Move supports 12 in. radially away from circle, carefully maintaining orientation and height for later reuse

Figure 54

46 Installation Procedures