Andrew ES45T manual Step

Step 10

Step 11

Step 12

Use a carpenter’s level to level support assembly as indicated in Figure 12. Loosen U- bolts to move support assembly up or down as needed to achieve level surface.

Figure 12

Tighten anchor bolts on rear pads and azimuth axis support base plate down using A- 325 procedure. See A-325 procedure for technique. (see page 12)

Loosely attach elevation strut (P/N 49766) to azimuth axis joint (P/N 300746) as shown in Figures 13 and 14.

•Use ¾ x 3-½ in. bolt, lockwasher and nut

Figure 13

18 Installation Procedures