Sub-Zero ICBBI-36UG manual ICE and Water Dispe NSE R, ICE DI Spen SER Operation, ICE Dispen SIN G

SU B-ZERO BUILT -I N USE & CARE

ICE AND WATER DISPE NSE R

For dispenser Models ICBBI-42SD and ICBBI-48SD, the automatic ice and water dis- penser gives you both ice and chilled water without having to open doors.

ICE DI SPEN SER OPERATION

To operate the ice dispenser for Models ICBBI-42SD and ICBBI-48SD, set a glass on the water grille of the glasswell, and press and hold the key pad on the glasswell until you have the ice you need. For larger quantities of ice, open the refrigerator door and place an ice con- tainer under the dispenser chute, then press the BULK ICE pad on the left hand wall inside the refrigerator section. Refer to the illustration below.

After initial ice maker start-up, discard the first few batches of ice—they may be discolored by the new system plumbing.

CAUTION

Use a sturdy glass to catch ice crescents. Fragile glasses can break. Also, to avoid breakage, make sure that the glass is sitting vertically on the water grille.

ICE DISPEN SIN G

Models ICBBI-42SD and ICBBI-48SD have a fea- ture that limits the maximum amount of ice that is dispensed each time the key pad on the glasswell is pressed.

To dispense ice, hold down the key pad for approximately two seconds. The dispenser will meter out ice for about two seconds, collect the ice directly above the glass, then drop the ice into the glass. If less ice is desired, hold the key pad down for less than two seconds. If more ice is desired, hold the key pad down until the dispensing cycle repeats.

IMPORTANT NOTE: Be sure that dispenser key pads are clean and dry when pressed to avoid problems with the dispenser operation.

ICE DI SPE NSE R OPERATING TIPS

If there’s no ice, make sure the ice maker system is turned on and indicator is illu- minated in the Control Center display panel.

Make sure there is a supply of ice in the ice bucket. See Ice Bucket Removal, page 9.

Make sure the ice bucket is all the way in and engaging the auger motor at the back of the bucket. If it is not all the way back, push on the ice bucket and depress the key pad on the glasswell at the same time.

Press the key pad on the glasswell. If you do not hear auger motor noise, wait five min- utes, then try again. If you do not hear auger noise after the second try, contact your Sub-Zero dealer.

If the ice dispenser is not used for a long period, the ice may fuse together. To avoid this, empty the ice bucket as needed.

WATE R DI SPENSE R OPERA TI ON

To operate the water dispenser for Models ICBBI- 42SD and ICBBI-48SD, set a glass on the water grille of the glasswell, and press and hold the key pad on the glasswell until the glass is filled.

The first time you use the water dispenser, purge the water system and storage tank for three min- utes. This will clear out any air in the system, along with foreign material in the new plumbing connection.

Initially, for water to dispense properly, the key pad must be depressed and held until water flows from the dispenser. You may have to hold the key pad for 60 seconds for water to fill the internal reservoir tank.

IMPORTANT NOTE: The chilled water reservoir tank is mounted inside the refrigerator section. It will take several hours to chill the water to the refrigerator temperature during the original fill or after a lot of water is used.

CAUTION

Limit continuous ice and/or water dispenser operation to seven minutes or less, to avoid damaging the equipment.

DISPEN SER LI GHTS

For dispenser models, there are three lighting states than can be cycled by pressing the key pad on the glasswell.

All lights OFF

All lights ON (blue key pad and white glasswell)

Key pad lights ON only

During water or ice dispensing, all lights will illu- minate until dispensing is complete, then lights will return to their previous state.

Lock

Indicator

Touch Pad

Water

Key Pad

Ice

Key Pad

Light

Key Pad

Water

Grille

Bulk Ice

Bezel

Glasswell— Models ICBBI-42SD	Bulk ice dispenser— Models
and ICBBI-48SD	ICBBI-42SD and ICBBI-48SD

11