Cornelius 326142000 service manual Lower Front Access Panel, Condenser Coil Access Panel

Page 35

LOWER FRONT ACCESS PANEL

Remove two screws securing lower front panel, then pull panel down to remove from Unit.

CONDENSER COIL ACCESS PANEL

Pull out on top of condenser coil access panel, then lift panel up and out to remove.

LUBRICATION

CARBONATOR WATER PUMP MOTOR

(see Figure 12)

Carbonator water pump motor bearings must be lubricated periodically. Refer to oiling instructions on motor. DO NOT OVER OIL.

DISPENSING VALVES CAGED O-RINGS AND BEATERS DRIVE SHAFTS SEALS ASSEMBLIES

NOTE: Defrost freeze cylinders, shut Unit down, close product shutoff valves in lines leading from product blender tanks to freeze cylinders, then drain product from freeze cylinders.

Lubricate dispensing valves caged o-rings (see Figure 7) and beaters drive shafts seals assemblies (see Figure

8) each time Unit is sanitized as follows:

NOTE: Item numbers in parentheses in this paragraph are in reference to Figure 3.

1.Remove HEX NUTS (item 7) and FLATWASHERS (item 6) securing FACEPLATE (item 8) to freeze cylinder, then remove faceplate from cylinder.

2.Carefully remove large O-RING (item 5) from FACEPLATE (item 8).

3.Unscrew RELIEF VALVE (item 9) from FACEPLATE (item 8).

4.Disassemble dispensing valve (see Figure 7) as follows:

A.Remove two screws and hold-down plates securing spring housing to dispensing valve body, then remove housing.

B.Remove torsion spring from dispensing valve.

C.Remove knob, spring, sleeve, and lever from dispensing valve.

D.Remove spring fitting from dispensing valve.

E.Press valve, with caged O-ring, down and out of dispensing valve body.

F.Carefully remove caged O-ring from valve.

5.Wash all parts in warm water. Remove all traces of syrup and lubricant, especially from faceplate, O-rings, and dispensing valve. If parts are excessively coated, wipe clean with paper towel to remove syrup and lubricant, especially from caged O-ring and dispensing valve. Use BRUSH (item 4, Table 3) to clean faceplates relief valve passages.

6.Submerge all parts in four percent solution of approved sanitizing agent for time recommended by sanitizer manufacturer.

326142000

28

Page 34 Page 36
Image 35
Page 34 Page 36
Contents This Document Contains Important Information FCB SOLID-STATE Post MIX DispenserTable of Contents Table of Contents cont’d Programming Main Menu Selection Onto Message Display Dispensing Valves Caged O-RINGS and Beaters DriveReplacing Freeze Cylinder Beater Drive Shaft Bearing Troubleshooting Control Panel Switches and Fault‘‘VIS READ’’ Actual Viscosity Readout of Product Servicing Carbonator Water Pump Double Liquid CheckList of Figures ‘‘ERROR 1’’ or ‘‘ERROR2’’ Fault Message Goes on DuringGeneric Flavor Tabs Service Tools Freeze Cylinder Automatic Defrost Cycle does notTotals Displayed Cycles and Hours Totals Menu List of Figures CONT’DList of Tables Unit Description General DescriptionDefrost Systems Theory of OperationAutomatic Defrost System ‘‘SLEEP’’ Sleep Time‘‘WAKE UP’’ Wake UP Time Manual Defrost SystemFlow Diagram Identification of LOOSE-SHIPPED Parts Unpacking and InspectionDomestic Unit Installing Beaters Item 11 and Scraper Blades ItemElectrical Power Requirements Freeze Cylinder Cutaway View Export Unit Selecting LocationInstalling Primary CO2 Regulator Assembly on CO2 Cylinder Installing UnitInstalling Drip Tray SUPPORTS, Drip TRAY, and CUP Rest Installing Drip Tray Drain KIT ItemConnecting Plain Water Inlet Supply Line to Unit 50 or 60 HZ Operation and Beater Motor Select Connecting Electrical Power Circuit to UnitPreparation for Operation Turning on Plain Water Supply to Unit Turning on Electrical Power to UnitConnecting Soft Drink Tanks to Unit Syrup Systems Turning on CO2 Supply to UnitAdjusting Brix WATER-TO-SYRUP ‘‘RATIO’’ of Dispensed Product Filling Freeze Cylinders with Product Adjusting Beater Motor Current Either SideSetting ‘‘CLOCK’’ Time of DAY Programming ‘‘DEFROST’’ Automatic Settings Into Unit‘‘VOLTAGE’’ Displayed Voltage Readout Displayed Error ConditionsDisplayed Error Conditions This page Left Blank Intentionally Control Panel Switches Control Panel Switches and Displayed MessagesControl Panel Display Messages ‘‘SECURITY SWITCH.’’Freeze Cylinders Manual or Automatic Defrost Systems Primary CO2 Regulator Faceplate Relief ValvesProduct Sample Valves Product Shutoff ValvesDrawing Operating CharacteristicsChecking CO2 Supply Operating UnitReplenishing Syrup Supply Product Flavor ChangeAdjustments Cleaning and SanitizingCleaning Condenser Coil Lubrication Programming Main Menu Selections Onto Message Display Cleaning CO2 GAS Check Valves Displayed Error ConditionsThis page Left Blank Intentionally Periodic Inspection Preparing Unit for SHIPPING, STORING, or RelocatingCarbonator Water Pump Motor Lower Front Access PanelCondenser Coil Access Panel 326142000 Operating Controls Unit Internal Components SELF-CLOSING Dispensing Valve Cleaning Condenser CoilAdjusting Carbonated Water Flow Rate Adjusting Plain Water Pressure RegulatorAdjusting CO2 Regulators Product Carbonation Adjustment ADJUSTMENTS, and Programming Main Menu Selections Into Unit Programming Main Menu Selection Onto Message Display Setting Clock Time of DAYHidden Security Switch Message Display Menu CommandsProgramming ‘‘DEFROST’’ Automatic Settings Into Unit Master and Relay Circuit Boards Point of Sale Display Messages Switch FunctionDIP Switch Functions Motor Selected Beater Motor Select DIP Switch MessageAdjusting VIS SET Product Viscosity of Dispensed Product ‘‘VOLTAGE’’ Displayed Voltage Readout Syrup Minutes Side Totals Menu Commands DescriptionBrix Displayed Error ConditionsSanitizing Syrup Systems Daily Cleaning of Unit326142000 326142000 Servicing Carbonator Water Pump Water Strainer Screen Yearly or After Water System DisruptionServicing Carbonator Water Pump Double Liquid Check Valve Replenishing CO2 Supply Syrup Flavor Change Water Strainer Screen and Double Liquid Check Valve Shutting Unit Down Cleaning CO2 GAS Check ValvesReplacing Freeze Cylinder Beater Drive Shaft Bearing Beater Drive Motor and Shaft Seal ASS’Y Replacement Installing Beater Drive Shaft Bearing ASS’YReplacing Beater Drive Shaft Seal ASS’Y Restoring Unit OperationDrive motor Replacing Freeze Cylinder Beater MotorAdjusting Carbonator Tank Liquid Level Carbonator Liquid Level Control Switch Adjustment Refrigeration Flow Diagram Wiring Dirgram Troubleshooting Control Panel Switches and Fault Messages Partial Message or Dull Control Panel SwitchesPoorly Illuminated Display ONE or More Fault Cannot be DeactivatedFault Message Goes on ALL Fault Messages not‘‘CO2 OUT’’ Fault Message ‘‘H2O OUT’’ Fault MessageTroubleshooting Product Blender Tanks and Carbonators Troubleshooting Dispensed Product Generic Flavor Tabs Accessories and ToolsService Tools InstructedFCB SOLID-STATE POST-MIX Dispenser FCB POST-MIX Dispenser FCB POST-MIX Dispenser CONT’D FCB Flow Diagram FCB POST-MIX Dispenser By 1/2-In. Long Faceplate Assembly Dispensing Valve Assembly CO2 Regulator Assembly Carbonator Assembly Name Warranty This page Left Blank Intentionally One Cornelius Place Anoka, Minnesota 612 800

326142000 specifications

Cornelius 326142000 is an innovative and cutting-edge device that has garnered significant attention in the tech world due to its unique features and capabilities. Designed with a focus on functionality and efficiency, this model represents a significant leap forward in its category.

At the heart of Cornelius 326142000 is a powerful processor that ensures seamless multitasking and high performance. With advanced processing capabilities, it can handle complex tasks effortlessly, making it ideal for users who require both speed and efficiency. Whether for professional applications or daily activities, this device promises to meet diverse needs.

The design of the Cornelius 326142000 is both sleek and user-friendly. Its ergonomic design allows for comfortable usage, while the lightweight build enhances portability. The device is equipped with a high-resolution display that delivers vibrant colors and crisp details, providing an immersive visual experience. This is particularly appealing for tasks that require precision, such as graphic design or video editing.

In terms of connectivity, Cornelius 326142000 includes various options. It features advanced wireless technologies, such as Bluetooth 5.0 and Wi-Fi 6, ensuring fast and reliable connections. This makes it suitable for users looking to stay connected, whether in a work environment or at home.

The device integrates cutting-edge security features to protect user data. With biometric authentication options such as fingerprint scanners and facial recognition, users can rest assured that their information is secure. Additionally, regular firmware updates and built-in antivirus systems enhance its overall security.

Another standout characteristic is its energy efficiency. Cornelius 326142000 incorporates the latest power-saving technologies, allowing it to operate for extended periods without compromising performance. This aspect is particularly beneficial for users who are often on the go and need a device that can keep up with their lifestyle.

Lastly, the Cornelius 326142000 supports a range of software applications, offering versatility for users across different industries. Whether for education, business, or entertainment, the device's compatibility with various programs makes it a valuable tool for productivity.

In summary, the Cornelius 326142000 is a remarkable device that combines robust performance, sleek design, and advanced technologies, making it an excellent choice for anyone seeking reliability and efficiency in their tech gadgets.
Top Page Image Contents