Appliance functions, Additional Functions

6. appliance functions

6.1DATE AND TIME SETTINGS : PUSH-BUTTON (5)

Set the machine to ON .
Press and hold down push-button 5	for more

than five seconds to access the date and time setting

function. Display 16

οC indicates in sequence

the abbreviations Hr (hours), Mn (minutes), dA (day), Mo (month) and Yr (year), while display

15	shows their respective settings. To scroll
the abbreviations, press push-button 5			.
To modify the settings, use push-buttons
7	and 8	.

6.2ICE CREAM SURFACE HARDENING PUSH-BUTTON (6)

Set the machine to ON .

Press and hold down push-button 6 for more than five seconds to access the surface hardening function (push-button LED flashes). The compressor

is switched on; display 15 shows the default cycle time. Set the cycle time (in minutes) by means

of push-buttons 7 and 8 . Open the cell door, place the product inside, then shut the door to start the cycle. All LEDs remain off, with the exception of the Start LED. When the cycle time has elapsed, an acoustic signal is given. The appliance remains on, ready for another ice cream hardening cycle. Open the cell door, remove the hardened product, replace it, then shut the door. The machine will perform another hardening cycle for the time set for the previous one. Every time the door is opened and closed after a cycle, the time is reset. To exit the function, press push-button 6

ADDITIONAL FUNCTIONS

6.3MUTING THE BEEPER AND ALARM RESET : PUSH-BUTTON (8)

Press push-button 8 to mute the alarm beeper.

Alarms are reset :

•by pressing push-button 8 when the beeper is off;

•automatically if alarm conditions are removed; see also section 7 (Alarm Management).

6.4 PROGRAM STORAGE:

PUSH-BUTTON (9)

The programming function is used for cycles for processing products with the same characteristics. Up to 99 programs can be stored. Select the type of chilling process (Soft, Hard, Timed Freezing or by Temperature), then press and hold push-button 9

PROGRAM until display 16		οC shows the abbreviation
P1 (push-button 9 PROGRAM LED flashes).
Use push-buttons 7		and 8		to set the number
of the program on display 16				οC . Start up the
cycle by pressing push-button 6				. When the cycle
has been completed, the appliance automatically
switches to the set storage temperature for an
indefinite time.
Press push-button 6		to set the appliance to STOP
status (relative LED switches off), ready for a new
cycle.
RECALLING A STORED PROGRAM
When the appliance is ON			, press push-button
9 PROGRAM briefly; display 16		οC	will show program
P1. Use push-buttons 7		and 8		to select the
required program. Start up the cycle by pressing
push-button 6	.