floor, you must adjust the feet to level the ice maker and lock the rollers. If the floor is level, just revolve the two front feet to touch the floor.
Reversing the door swing
Tools needed: flathead screwdriver, Phillips screwdriver
IMPORTANT: Before you begin, unplug the ice maker or disconnect power.
To remove door from hinges:
1.Remove the top hinge cover.
2.Using a Phillips screwdriver, remove the screws, then remove the top hinge mat and top hinge. Keep the parts together and set them aside.
3.Lift the door off of the bottom hinge and set the door aside.
To replace door on hinges:
1.Using a flathead screwdriver, remove the plug buttons from the screw holes opposite the door hinges, top and bottom. Set aside.
2.Remove the front louver. Set aside.
3.Remove the bottom hinge and place it on the opposite side at the bottom of the door.
4.Position the door on the bottom hinge.
5.Align the door on the bottom hinge and replace the top hinge and top hinge mat.
6.Replace top hinge cover.
7.Push the plug buttons into the original screw holes.
See Figure below.
11