TROUBLESHOOTING
Before Calling for Service
If the unit appears to be malfunctioning, read through the OPERATION section of this manual first. If the problem persists, check the Troubleshooting Guide on the following pages. Some of the problems mentioned in the Guide can be solved easily without a service call.
Troubleshooting Guide
Problem
The machine does not operate.
The water doesn't feed in after the machine starts.
Machine makes ice, but bin does not fill up with ice.
Water is leaking out of the unit.
Possible Cause | Probable Correction |
The ice maker is unplugged. | Plug the ice maker in. |
The fuse is blown. | Replace fuse. If it happens again, call for |
| service to check for a short circuit in the unit. |
The ice maker power button | Switch the ice maker power button to ON. |
is set at OFF. |
|
The ice storage bin is full of | Remove some ice cubes. Be sure the |
ice. | probe is free of ice. |
The drainage tray on top of | Drain off water by unscrewing the lower |
the compressor is full. | drainage nut. |
The water supply tap is | Turn on the water supply tap. |
turned off. |
|
The water supply pipe is not | Reconnect the water supply pipe. |
properly connected. |
|
The condenser may be dirty. | Clean the condenser. |
The air flow to the ice maker | Check the installation. |
may be obstructed. |
|
The ambient temperature and | Check the installation. |
water temperature are high, |
|
or unit is near some heat |
|
source. |
|
Some water falls to the floor | Normal condensation on the door or some |
when you open the door to | water together with ice. Take care when you |
remove ice from storage bin. | take out ice. |
Water supply connection is | Tighten fitting. See Connecting the water |
leaking. | line. |
Drain pipe higher than drain | Lower drain pipe. |
outlet. |
|
24