The water dispenser will not operate properly
WATER FILTER CERTIFICATIONS
■Freezer door closed completely? Close the door firmly. If it does not close completely, see “The doors will not close
completely.”
■Refrigerator connected to a water supply and the supply
shutoff valve turned on? Connect refrigerator to water supply and turn water shutoff valve fully open.
■ Is the water pressure at least 30 psi? The water pressure to the home determines the flow from the dispenser. See “Water Supply Requirements.”
■ Kink in the home water source line? Straighten the water source line.
■ New installation? Flush and fill the water system.
■ Water filter installed on the refrigerator? The filter may be clogged or incorrectly installed.
■Is a reverse osmosis water filtration system connected to
your cold water supply? See “Water Supply Requirements” in either the Installation Instructions or the Use & Care Guide.
Water is leaking from the dispenser
NOTE: One or two drops of water after dispensing is normal.
■Glass not being held under the dispenser long enough? Hold the glass under the dispenser 2 to 3 seconds after releasing the dispenser lever.
■New installation? Flush the water system. See “Water and Ice Dispensers.”
■Recently changed water filter? Flush the water system. See
“Water and Ice Dispensers.”
The dispenser water is not cool enough
NOTE: Water from the dispenser is chilled to only 50°F (10°C).
■ New installation? Allow 24 hours after installation for the water supply to cool completely.
■Recently dispensed large amount of water? Allow 24 hours for water supply to cool completely.
■ Water not been recently dispensed? The first glass of water may not be cool. Discard the first glass of water.
■Refrigerator connected to a cold water pipe? Make sure
the refrigerator is connected to a cold water pipe. See “Water Supply Requirements.”
11