Zanussi ZKT6050 user manual Residual heat HOB, To fit the top oven shelf

Page 14

IMPORTANT!

Occasionally the heated areas may be seen to switch on and off when higher heat settings are being used. This is due to a safety device, which prevents the glass from overheating.

Some switching on and off when cooking at high temperatures, e.g. deep fat frying is quite normal, causes no damage to the hob and little delay in cooking times.

Excessive switching may however be caused by the use of an unsuitable saucepan or a saucepan which is smaller than the heated area. If excessive switching occurs, discontinue use of the saucepan.

Residual heat HOB

When a hob function has been switched off the residual heat indicator will remain alight to indicate that the hob is still hot. ‘ H‘ will show in the display until the appliance has cooled. If the appliance is switched off at the supply before the hob has fully cooled, the residual heat indicator will remain illuminated when the electricity is restored. This is a safety precaution.

To fit the top oven shelf

The shelf should be fitted with the straight rods uppermost on the frame and the forms towards the back of the oven.

14

To remove a shelf slide the shelf towards you until the shelf stop is reached. Tilt shelf up at the front to that the stops clear the side supports. Lift shelf clear. To install a shelf, reverse the above steps. Each shelf position has an upper and lower support.

WARNING!

Do not place cookware and cooking pots with rough bases e.g. cast iron on the oven door as damage to the glass may occur.

Top oven intelligent grill

WARNING!

CAUTION: Accessible parts may be hot when the grill is in use. Young children should be kept away.

Using intelligent grill

The oven must be switched on before setting any cooking function or programme.

Press the Oven Cavity selector until the top oven cavity indicator is illuminated.

Press the Function selector until the required setting is shown .

To use the grill at lower settings press the function selector untill the required setting is shown .

Wait 5 seconds until your choice is confirmed. The temperature will automatically set to 250°C if grilling with the door closed.

Image 14
Contents User Manual Cooker Contents Child safety Important safety instructionsInstallation During useCleaning and maintenance Extreme care must be taken when using a ceramic hob scraperProduct description Controls and their functionsRating plate Before using the applianceSwitching the hob on/off Touch control sensorsOperating time Switching the oven on/offCookware Condensation and steamGrill and oven furniture To set the countdown Electronic timerTo set the time of day To set the timer to switch off only To cancel the countdownTo set the timer to switch on and off automatically To set the oven timer controlThings to note Automatic cookingTo return the appliance to manual Turn off the oven controlsUsing the hob timer Using the hobUsing the stop + go function Operation Ceramic hobSafety cut-out Setting the timeSwitching off the acoustic signal Selecting a cooking zoneTo fit the top oven shelf Top oven intelligent grill Using intelligent grillResidual heat HOB Always remove the grill pan handle during grilling Grill pan and handleEnsure the handle is correctly located Using the top oven Top ovenMain oven fan cooking Using main oven fan cookingMain oven grill To fit the main oven shelvesDefrost Using defrostChild lock Activating the child lockSwitching on after a safety cut- out Temperature reviewOven Safety cut-out Function lockGrilling chart FoodTop oven cooking chart TOP Oven Food POS Cooking Approx Temp CFood TOP Oven POS Cooking Approx Temp C Main oven cooking chart Food Cooking Approx Temp CMain oven cooking chart Cooking Time Roasting chartMeattemperature Hints and tips when using the hob Hints and tipsHints and tips when defrosting Care and cleaning To reduce marking of the hob Cleaning the grill/oven furnitureCleaning inside the grill and oven compartments Avoid the useAerosol cleaners must not be used on Stay- clean surfaces Cleaning the doorsCleaning between the outer and inner door glass To remove the glassTop Oven To clean the glass door panelsTo replace the door glass Main OvenReplacing an oven light bulb Type of bulb required is a 300C 25 watt small Edison ScrewTimer does not work Oven is not cooking evenly TroubleshootingProblem Possible SolutionOven light fails to illuminate Oven fan is noisy This appliance must be earthed Installation instructionsConnecting to the electricity supply Mains terminal cover SafetyWe recommend you use a new length Ensure that the cover is securely fastenedTechnical details EnvironmentGuarantee / Customer care Standard guarantee conditionsPage 349151003 04/2007