Zanussi ZDS 699 EX Water outlet hose connection, Waste connection must be at a height of between

Page 27

Water outlet hose connection

The end of the drain hose can be connected in the following ways:

1.To the sink outlet siphon, securing it if necessary with a clip.

2.To a stand pipe provided with vent-hole, minimum internal diameter 4 cm.

The waste connection must be at a height of between

30 cm (minimum) and 100 cm (maximum) from the bottom of the dishwasher.

The drain hose can face either to the right or left of the dishwasher

Ensure the hose is not bent or squashed as this could prevent or slow down the discharge of water.

If you use a drain hose extension it must be no longer than 2 metres and its internal diameter must be no smaller than the diameter of the hose provided.

Likewise the internal diameter of the couplings used for connections to the waste outlet must be no smaller than the diameter of the hose provided.

The sink plug must not be in place when the machine is draining as this could cause the water to siphon back into the machine.

			1	2
	Ø	21		4 cm
		21		min
		Ø	18	min
			18

				min 30 cm max 100 cm
	CS13

Ø 18	Ø 21
+ 2 m max		min 30 cm max 100 cm
CS14

27

COL12en

Image 27

Contents Dishwasher Contents During Use Important safety informationInstallation Child SafetyWater tap Control panelOpen door SaltCycle will be carried out Aid is automatically excludedAudible signals Use salt from level 1 upwards Setting the water softenerBefore use PressFilling with salt To fillTo fill with salt, unscrew the cap of the salt container Adjusting the dose Rinse aidEnsure that the lid is closed after every refill Open the door and slide out the baskets to load the dishes Using your applianceLoading your appliance Lower basketCutlery basket Removable knife basketFor best results use the cutlery grid/s inserts provided To move to the higher position proceed as follows Adjusting the height of the upper basketWhen the top basket is in the higher Upper basketCompact detergents with enzymes If using powder detergents proceed as followsIf using detergent in tablets proceed as follows Use of detergentItems not suitable for dishwashers Hints and tipsTo save energy For best washing resultsWashing programmes Operating sequence Current programme It is now possible to select a new washing programmeAt the end of the washing programme Internal cleaning Cleaning the central filterCleaning the large filter Moving the machine External cleaningFrost precautions Leave the inside of the machine cleanActions listed below Something not workingSlough Berkshire Service and spare partsProtection against flooding Customer Care DepartmentThis guarantee does not cover Guarantee conditionsStandard guarantee conditions European GuaranteeTo contact your local Zanussi Service Centre telephone Zanussi Service ForceMidlands Hints for test centres Technical specificationsLocknut must be correctly fitted to avoid water leaks Installation instructionsWater supply connections Nevertheless we advise a cold water supplyWaste connection must be at a height of between Water outlet hose connectionElectrical connection Recess height may be anywhere between 820 Building-inTo fit the pad, press it onto the rear foot Width 596 mm Height Furniture door plinthMounting the infill panel Fixing to the adjacent unitsKitchen plinth adjustment Fitting the vapour protectionNoise protection Electrolux Household Appliances Limited From the Electrolux Group. The world’s No.1 choice