Operating sequence

Zanussi ZDS 699 EX manual Operating sequence

Page 16

1.Check the filters

Ensure they are clean and properly positioned (see "Maintenance and cleaning").

2.Press the On/Off push button

The display will show the last selected programme and the corresponding phase indicator lights will illuminate.

If the door is open also the "open door" indicator light will illuminate.

3.Check that there is rinse aid

and salt

The corresponding indicator lights will illuminate if refilling is necessary.

4.Load the dishes

Remove any scraps of food.

Pull the lower basket out and arrange the saucepans, plates and cutlery in it.

Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. in it.

Slide the baskets back into the machine.

5.Ensure that the spray arms can rotate freely.

6.Measure out detergent

Add the required amount of detergent into the dispenser.

Close the detergent dispenser lid.

7.Close the dishwasher door

8a. Setting and starting the programme without "delay start"

Press the "programme selector" push button until the required programme number appears in the digital display.

The following options may also be selected:

a-	Half load	by pressing the corresponding
	push button.
b-	Eco drying	by pressing the corresponding
	push button.
	Press the	START	push button, an audible

signal advises you that the programme has started.

The display will show the running time

of the programme and the indicator lights of the phases will turn off except for the indicator light of the current phase.

The time in the digital display will start to decrease from minute to minute.

Pressing the "programme selector"

push button while the programme is running will display the number of the current programme.

If the door is opened during the run of the programme the current phase will be interrupted and the digital display will show the number of the programme. The indicator light of the interrupted phase will start to flash and the indicator light "open door" will illuminate.

Once the door is closed the programme will start from the point where it was interrupted.

SEQ06en

Image 16

Contents

Dishwasher Contents Important safety information InstallationChild Safety During UseControl panel Open doorSalt Water tapAid is automatically excluded Cycle will be carried outAudible signals Setting the water softener Before usePress Use salt from level 1 upwardsTo fill Filling with saltTo fill with salt, unscrew the cap of the salt container Rinse aid Adjusting the doseEnsure that the lid is closed after every refill Using your appliance Loading your applianceLower basket Open the door and slide out the baskets to load the dishesRemovable knife basket Cutlery basketFor best results use the cutlery grid/s inserts provided Adjusting the height of the upper basket When the top basket is in the higher Upper basket To move to the higher position proceed as followsIf using powder detergents proceed as follows If using detergent in tablets proceed as followsUse of detergent Compact detergents with enzymesHints and tips To save energyFor best washing results Items not suitable for dishwashersWashing programmes Operating sequence It is now possible to select a new washing programme Current programmeAt the end of the washing programme Cleaning the central filter Internal cleaningCleaning the large filter External cleaning Frost precautionsLeave the inside of the machine clean Moving the machineSomething not working Actions listed belowService and spare parts Protection against floodingCustomer Care Department Slough BerkshireGuarantee conditions Standard guarantee conditionsEuropean Guarantee This guarantee does not coverZanussi Service Force To contact your local Zanussi Service Centre telephoneMidlands Technical specifications Hints for test centresInstallation instructions Water supply connectionsNevertheless we advise a cold water supply Locknut must be correctly fitted to avoid water leaksWater outlet hose connection Waste connection must be at a height of betweenElectrical connection Building-in Recess height may be anywhere between 820To fit the pad, press it onto the rear foot Furniture door plinth Mounting the infill panelFixing to the adjacent units Width 596 mm HeightFitting the vapour protection Kitchen plinth adjustmentNoise protection From the Electrolux Group. The world’s No.1 choice Electrolux Household Appliances Limited

Zanussi ZDS 699 EX manual Operating sequence