Zanussi ZDS 699 EX manual Building-in, Recess height may be anywhere between 820

Page 29

Building-in

This dishwasher is designed to be fitted under a kitchen counter or worksurface.

It is essential that the recess dimensions indicated in the diagram are followed.

No further openings for venting of the dishwasher are required, but only to let the water fill and drain hose and power supply cable pass through.

The recess height may be anywhere between 820 and

880 mm from the floor as the dishwasher incorporates adjustable feet (max 60 mm).

A distance of 2 mm should be allowed between the top of the dishwasher and the counter top.

Adjusting the height of the appliance

To adjust the height proceed as follows:

1.Loosen or tighten the two front feet.

2.The rear foot is adjusted by turning the screw in the middle of the front kick plate to the left or right.

A pad is supplied for the rear foot to make sliding the appliance in and out of the recess easier.

To fit the pad, press it onto the rear foot.

If required, the dimensions of this pads can be reduced by breaking it where marked.

	596	880
		−
		820
	90	820
	5
	max
	878	600
	878
	−
	818
	-
	+
	II123

II52

Good levelling is essential for correct closure and sealing of the door. When the appliance is correctly levelled, the door will not catch on the levelling spacers on either side of the cabinet.

If the door does not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level.

IN11

IN12

29

INS25UKen

Image 29

Contents Dishwasher Contents Installation Important safety informationChild Safety During UseOpen door Control panelSalt Water tapCycle will be carried out Aid is automatically excludedAudible signals Before use Setting the water softenerPress Use salt from level 1 upwardsTo fill with salt, unscrew the cap of the salt container Filling with saltTo fill Ensure that the lid is closed after every refill Adjusting the doseRinse aid Loading your appliance Using your applianceLower basket Open the door and slide out the baskets to load the dishesFor best results use the cutlery grid/s inserts provided Cutlery basketRemovable knife basket When the top basket is in the higher Adjusting the height of the upper basketUpper basket To move to the higher position proceed as followsIf using detergent in tablets proceed as follows If using powder detergents proceed as followsUse of detergent Compact detergents with enzymesTo save energy Hints and tipsFor best washing results Items not suitable for dishwashersWashing programmes Operating sequence At the end of the washing programme Current programmeIt is now possible to select a new washing programme Cleaning the large filter Internal cleaningCleaning the central filter Frost precautions External cleaningLeave the inside of the machine clean Moving the machineActions listed below Something not workingProtection against flooding Service and spare partsCustomer Care Department Slough BerkshireStandard guarantee conditions Guarantee conditionsEuropean Guarantee This guarantee does not coverTo contact your local Zanussi Service Centre telephone Zanussi Service ForceMidlands Hints for test centres Technical specificationsWater supply connections Installation instructionsNevertheless we advise a cold water supply Locknut must be correctly fitted to avoid water leaksWaste connection must be at a height of between Water outlet hose connectionElectrical connection To fit the pad, press it onto the rear foot Recess height may be anywhere between 820Building-in Mounting the infill panel Furniture door plinthFixing to the adjacent units Width 596 mm HeightNoise protection Kitchen plinth adjustmentFitting the vapour protection Electrolux Household Appliances Limited From the Electrolux Group. The world’s No.1 choice