Zanussi ZDS 699 EX Fitting the vapour protection, Noise protection, Kitchen plinth adjustment

Page 31

Fitting the vapour protection

Fit the adhesive protection foil onto the front part of the worktop; along the entire width.

Noise protection

Adhesive noise protection ensures excellent noise insulation. This should be fitted when the dishwasher has been mounted in the recess and the height adjusted.

Apply the protection as shown in the drawing, making sure that the non-adhesive section reaches right down to the floor.

Kitchen plinth adjustment

To allow correct opening of the door it is sometimes necessary to cut the kitchen plinth. Refer to the cutting table.

According to dimensions (	a ) and ( b ) as shown on the
figure, you will find on the following table the depth (		x )
of the cut to be made on the plinth.

The dimensions ( a ) and ( b ) of the table are those most frequently used in the kitchen furnitures.

Depth ( b )*

II21

II61

	a
II15	b
II15		II111
		II111
	Height (	a )*

	170	160	150	140	130	120	110	100	90

40	136	131	125	118	110	100	93	85	75

50	135	131	125	118	110	102	92	85	75

60	137	132	125	118	110	102	94	85	75

70	138	134	128	120	110	104	95	85	75		X

80	/	139	130	124	115	105	98	88	78

90	/	/	138	129	120	110	100	90	80

100	/	/	/	135	125	115	105	95	85

( )dimensions in mm			600 mm
*			minimum

X

Dimensions of the cut on the plinth

31

INS71en

Image 31

Contents Dishwasher Contents During Use Important safety informationInstallation Child SafetyWater tap Control panelOpen door SaltCycle will be carried out Aid is automatically excludedAudible signals Use salt from level 1 upwards Setting the water softenerBefore use PressTo fill Filling with saltTo fill with salt, unscrew the cap of the salt container Rinse aid Adjusting the doseEnsure that the lid is closed after every refill Open the door and slide out the baskets to load the dishes Using your applianceLoading your appliance Lower basketRemovable knife basket Cutlery basketFor best results use the cutlery grid/s inserts provided To move to the higher position proceed as follows Adjusting the height of the upper basketWhen the top basket is in the higher Upper basketCompact detergents with enzymes If using powder detergents proceed as followsIf using detergent in tablets proceed as follows Use of detergentItems not suitable for dishwashers Hints and tipsTo save energy For best washing resultsWashing programmes Operating sequence It is now possible to select a new washing programme Current programmeAt the end of the washing programme Cleaning the central filter Internal cleaningCleaning the large filter Moving the machine External cleaningFrost precautions Leave the inside of the machine cleanActions listed below Something not workingSlough Berkshire Service and spare partsProtection against flooding Customer Care DepartmentThis guarantee does not cover Guarantee conditionsStandard guarantee conditions European GuaranteeTo contact your local Zanussi Service Centre telephone Zanussi Service ForceMidlands Hints for test centres Technical specificationsLocknut must be correctly fitted to avoid water leaks Installation instructionsWater supply connections Nevertheless we advise a cold water supplyWaste connection must be at a height of between Water outlet hose connectionElectrical connection Building-in Recess height may be anywhere between 820To fit the pad, press it onto the rear foot Width 596 mm Height Furniture door plinthMounting the infill panel Fixing to the adjacent unitsFitting the vapour protection Kitchen plinth adjustmentNoise protection Electrolux Household Appliances Limited From the Electrolux Group. The world’s No.1 choice