GE 164D3333P172 owner manual Oven Control Settings

Page 13

9

 

10

12

 

 

 

11

 

 

Oven Control Settings

 

 

9

OVEN ON Light

 

Glows anytime the oven is heating. The light will flash

 

 

when the oven automatically turns off to remind you to

 

 

turn the Oven Temperature knob to OFF.

 

10

CLEAN Light

 

Glows when the oven is in the self-clean cycle. After the

self-clean cycle, the light will flash. Unlatch the door and turn the Oven Temperature knob to OFF.

NOTE: Do not lock the oven door with the latch during cooking. The latch is used for self-cleaning only.

11

PREHEATED Light

Glows when the oven reaches your selected

 

temperature.

12

Oven Temperature Knob

Turn this knob to the setting you want. The temperature

will be displayed to indicate setting. Display will change back to time after a few seconds.

As a safety feature, this oven will automatically shut off after 12 hours.

On models with touch pad clock controls this feature may be deactivated to allow the oven to be left on for more than 12 hours.

To deactivate or reactivate the Automatic Oven Shut-Off, press and hold both the MIN. +/– pads for about 4 seconds.

On some models you may use the oven light switch to turn the light on and off when the door is closed.

Safety Information Operating Instructions Installation Instructions Troubleshooting Tips Customer Service

13

Image 13
Contents GE Answer Center GE AppliancesCongratulations You Are Now Part of the GE Family Staple sales slip or cancelled check hereWrite the model and serial numbers here GE & You Service Partnership All ranges can tip and injury could result Fiberglass insulation in self-clean ovens gives off a veryCalifornia Safe Drinking Water and Toxic Enforcement Cycle. Exposure can be minimized by venting with an openSafety Precautions Safety Information Oven SELF-CLEANING Oven Surface Cooking Units REMEMBER… Customer Service Troubleshooting TipsHow to Set Using the surface unitsSurface Cookware Tips Wok CookingCustomer Service Using the oven controlsOven Control Settings How to Set the Oven for Baking or Roasting Using the ovenBefore you begin… Type of margarine will affect baking performanceHow to Set the Oven for Broiling Preheating and Pan PlacementAluminum Foil Comments Broiling guideUsing the clock and timer Automatic Stop How to Set an Immediate StartMake sure the oven clock shows the correct time of day Press Cook Time ON/OFFFor Models with Pads and an Oven Temperature Knob For Models with Only an Oven Temperature KnobBefore a Clean Cycle Using the self-cleaning ovenHow to Set the Oven for Cleaning After a Clean Cycle How to Delay the Start of CleaningPress the Start Time ON/OFF pad Control Panel and Knobs Care and cleaning of the rangeOven Vent Painted SurfacesTo clean the outside of the door To clean the inside of the doorLift-Off Oven Door Do not lift the door by the handleOven Heating Elements Oven Light Replacement on some modelsOven Shelves To remove the coverTo remove the storage drawer Broiler Pan & GridTo replace the storage drawer Lift-Up Cooktop on some models Porcelain Enamel CooktopDrip Pans Surface UnitsTo remove a surface unit To replace a surface unitWiring must conform to National Electric Codes Installation of the rangePrepare the Opening Prepare for Electrical Connection Flooring Under the RangeBe installed before reinstalling the rear range wiring cover Power Cord Strain Relief InstallationDo not remove ground strap connection Wire Power Cord InstallationBefore After Local codes Wire Conduit InstallationConnector block terminal Bare wire Leveling the Range Anti-Tip Bracket InstallationFinal Check Before you call for service… Instructions Operating Instructions Customer Service Troubleshooting Tips InstallationFood does not bake Or roast properlyClock and timer Oven temperatureSelf-clean Self-clean cycleAfter a clean cycle Oven not cleanClean light To CleanPower outage Is on when youWant to cook A numberCustomer Service We Will Replace, At No Charge To You GE Electric Range WarrantyOne Year From the dateIn-Home Repair Service 800-GE-CARES Service Telephone NumbersTDD 800-TDD-GEAC