GE 164D3333P172 Is on when you, Want to cook, A number, Flash in the display, Power outage

Page 41

Problem

Possible Causes

What To Do

 

 

 

CLEAN light

The oven door was

Turn the Oven

is on when you

accidentally locked.

Temperature knob to OFF.

want to cook

 

Allow the oven to cool.

 

 

Never force the door

 

 

latch handle.

 

 

 

“F—and a number”

You have a function

If a function error code

flash in the display

error code.

appears during the self-

 

 

cleaning cycle, check the

 

 

oven door latch. The latch

 

 

may have been moved, even

 

 

if only slightly, from the

 

 

locked position. Make sure

 

 

the latch is moved to the

 

 

right as far as it will go. Turn

 

 

the Oven Temperature

 

 

knob to OFF. Allow the

 

 

oven to cool for one hour.

 

 

Put the oven back into

 

 

operation.

 

 

Disconnect all power to

 

 

the range for 5 minutes

 

 

and then reconnect power.

 

 

If the function error code

 

 

repeats, call for service.

 

 

 

Power outage

Power outage or surge.

Some models will

 

 

automatically resume their

 

 

setting once the power is

 

 

restored. On models with a

clock, you must reset the clock. If the oven was in use, you must reset it by turning the Oven Temperature knob back to OFF, setting the clock and resetting any cooking function.

Safety Information Operating Instructions Installation Instructions Troubleshooting Tips Customer Service

41

Image 41
Contents GE Answer Center GE AppliancesWrite the model and serial numbers here Staple sales slip or cancelled check hereCongratulations You Are Now Part of the GE Family GE & You Service Partnership All ranges can tip and injury could result Fiberglass insulation in self-clean ovens gives off a veryCalifornia Safe Drinking Water and Toxic Enforcement Cycle. Exposure can be minimized by venting with an openSafety Precautions Safety Information Oven SELF-CLEANING Oven Surface Cooking Units REMEMBER… Customer Service Troubleshooting TipsHow to Set Using the surface unitsSurface Cookware Tips Wok CookingCustomer Service Using the oven controlsOven Control Settings How to Set the Oven for Baking or Roasting Using the ovenBefore you begin… Type of margarine will affect baking performanceAluminum Foil Preheating and Pan PlacementHow to Set the Oven for Broiling Comments Broiling guideUsing the clock and timer Automatic Stop How to Set an Immediate StartMake sure the oven clock shows the correct time of day Press Cook Time ON/OFFFor Models with Pads and an Oven Temperature Knob For Models with Only an Oven Temperature KnobHow to Set the Oven for Cleaning Using the self-cleaning ovenBefore a Clean Cycle Press the Start Time ON/OFF pad How to Delay the Start of CleaningAfter a Clean Cycle Control Panel and Knobs Care and cleaning of the rangeOven Vent Painted SurfacesTo clean the outside of the door To clean the inside of the doorLift-Off Oven Door Do not lift the door by the handleOven Heating Elements Oven Light Replacement on some modelsOven Shelves To remove the coverTo replace the storage drawer Broiler Pan & GridTo remove the storage drawer Lift-Up Cooktop on some models Porcelain Enamel CooktopDrip Pans Surface UnitsTo remove a surface unit To replace a surface unitWiring must conform to National Electric Codes Installation of the rangePrepare the Opening Prepare for Electrical Connection Flooring Under the RangeBe installed before reinstalling the rear range wiring cover Power Cord Strain Relief InstallationDo not remove ground strap connection Wire Power Cord InstallationBefore After Local codes Wire Conduit InstallationConnector block terminal Bare wire Final Check Anti-Tip Bracket InstallationLeveling the Range Before you call for service… Instructions Operating Instructions Customer Service Troubleshooting Tips InstallationFood does not bake Or roast properlyClock and timer Oven temperatureSelf-clean Self-clean cycleAfter a clean cycle Oven not cleanClean light To CleanPower outage Is on when youWant to cook A numberCustomer Service We Will Replace, At No Charge To You GE Electric Range WarrantyOne Year From the dateTDD 800-TDD-GEAC Service Telephone NumbersIn-Home Repair Service 800-GE-CARES