GE 164D3333P172 Excessive smoking, Oven door will, Not unlock, Oven not clean, Clean light

Page 40

Customer Service Troubleshooting Tips Installation Instructions Operating Instructions Safety Information

Before you call for service…

Troubleshooting Tips

Problem		Possible Causes	What To Do

Excessive smoking		Excessive soil.	• Turn the Oven
			Temperature knob to OFF.
			Open the windows to rid
			the room of smoke. Wait
			until the CLEAN light goes
			off. Wipe up the excess soil
			and reset the clean cycle.
Oven door will		Oven too hot.	• Allow the oven to cool
not unlock			below locking temperature.
Oven not clean		Oven controls not	• See Using the self-cleaning
after a clean cycle		properly set.	oven section.

		Oven was heavily soiled.	• Clean up heavy spillovers
			before starting the clean
			cycle. Heavily soiled ovens
			may need to self-clean
			again or for a longer
			period of time.

CLEAN light		Oven controls not	• Move the door latch
flashes		properly set.	handle to the right
			before setting the Oven
			Temperature knob
			to CLEAN.

Oven door is		The door is out	• Because the oven door is
crooked		of position.	removable, it sometimes
			gets out of position during
			installation. To straighten
			the door, push down on
			the high corner.

Oven makes		This is the sound	• This is normal.
clicking noise		of the heating element
		turning off and on
		during cooking functions.

40

Image 40

Contents GE Appliances GE Answer CenterCongratulations You Are Now Part of the GE Family Staple sales slip or cancelled check hereWrite the model and serial numbers here GE & You Service Partnership Fiberglass insulation in self-clean ovens gives off a very All ranges can tip and injury could resultCalifornia Safe Drinking Water and Toxic Enforcement Cycle. Exposure can be minimized by venting with an openSafety Precautions Safety Information Oven SELF-CLEANING Oven Surface Cooking Units Customer Service Troubleshooting Tips REMEMBER…Using the surface units How to SetSurface Cookware Tips Wok CookingUsing the oven controls Customer ServiceOven Control Settings Using the oven How to Set the Oven for Baking or RoastingBefore you begin… Type of margarine will affect baking performanceHow to Set the Oven for Broiling Preheating and Pan PlacementAluminum Foil Broiling guide CommentsUsing the clock and timer How to Set an Immediate Start Automatic StopMake sure the oven clock shows the correct time of day Press Cook Time ON/OFFFor Models with Only an Oven Temperature Knob For Models with Pads and an Oven Temperature KnobBefore a Clean Cycle Using the self-cleaning ovenHow to Set the Oven for Cleaning After a Clean Cycle How to Delay the Start of CleaningPress the Start Time ON/OFF pad Care and cleaning of the range Control Panel and KnobsOven Vent Painted SurfacesTo clean the inside of the door To clean the outside of the doorLift-Off Oven Door Do not lift the door by the handleOven Light Replacement on some models Oven Heating ElementsOven Shelves To remove the coverTo remove the storage drawer Broiler Pan & GridTo replace the storage drawer Porcelain Enamel Cooktop Lift-Up Cooktop on some modelsSurface Units Drip PansTo remove a surface unit To replace a surface unitInstallation of the range Wiring must conform to National Electric CodesPrepare the Opening Flooring Under the Range Prepare for Electrical ConnectionPower Cord Strain Relief Installation Be installed before reinstalling the rear range wiring coverWire Power Cord Installation Do not remove ground strap connectionBefore After Wire Conduit Installation Local codesConnector block terminal Bare wire Leveling the Range Anti-Tip Bracket InstallationFinal Check Before you call for service… Customer Service Troubleshooting Tips Installation Instructions Operating InstructionsFood does not bake Or roast properlyOven temperature Clock and timerSelf-clean Self-clean cycleOven not clean After a clean cycleClean light To CleanIs on when you Power outageWant to cook A numberCustomer Service GE Electric Range Warranty We Will Replace, At No Charge To YouOne Year From the dateIn-Home Repair Service 800-GE-CARES Service Telephone NumbersTDD 800-TDD-GEAC