GE 164D3333P172 Installation of the range, Wiring must conform to National Electric Codes

Page 28

Customer Service Troubleshooting Tips Installation Instructions Operating Instructions Safety Information

Installation of the range.

Read these instructions completely and carefully.

Before You Begin

IMPORTANT: Save these instructions for the local electrical inspector’s use.

IMPORTANT: OBSERVE ALL GOVERNING CODES AND

ORDINANCES.

NOTE TO INSTALLER: Leave these instructions with the appliance after installation is completed.

NOTE TO CONSUMER: Keep this Owner’s Manual and

Installation Instructions for future use.

NOTE: This appliance must be properly grounded.

Tools You Will Need

Large blade screwdriver

1/4″ hex head nutdriver

Channel lock pliers

Electrical Requirements

CAUTION, FOR PERSONAL SAFETY: DO NOT USE AN

EXTENSION CORD WITH THIS APPLIANCE.

REMOVE HOUSE FUSE OR OPEN CIRCUIT BREAKER

BEFORE BEGINNING INSTALLATION.

This appliance must be supplied with the proper voltage and frequency, and connected to an individual, properly grounded branch circuit, protected by a circuit breaker or time delay fuse, as noted on the rating plate.

Wiring must conform to National Electric Codes.

If the electric service provided does not meet the above specifications, have a licensed electrician install an approved outlet.

Because range terminals are not accessible after range is in position, flexible service conduit or cord must be used.

28

Image 28
Contents GE Appliances GE Answer CenterCongratulations You Are Now Part of the GE Family Staple sales slip or cancelled check hereWrite the model and serial numbers here GE & You Service Partnership Fiberglass insulation in self-clean ovens gives off a very All ranges can tip and injury could resultCalifornia Safe Drinking Water and Toxic Enforcement Cycle. Exposure can be minimized by venting with an openSafety Precautions Safety Information Oven SELF-CLEANING Oven Surface Cooking Units Customer Service Troubleshooting Tips REMEMBER…Using the surface units How to SetSurface Cookware Tips Wok CookingUsing the oven controls Customer ServiceOven Control Settings Using the oven How to Set the Oven for Baking or RoastingBefore you begin… Type of margarine will affect baking performanceHow to Set the Oven for Broiling Preheating and Pan PlacementAluminum Foil Broiling guide CommentsUsing the clock and timer How to Set an Immediate Start Automatic StopMake sure the oven clock shows the correct time of day Press Cook Time ON/OFFFor Models with Only an Oven Temperature Knob For Models with Pads and an Oven Temperature KnobBefore a Clean Cycle Using the self-cleaning ovenHow to Set the Oven for Cleaning After a Clean Cycle How to Delay the Start of CleaningPress the Start Time ON/OFF pad Care and cleaning of the range Control Panel and KnobsOven Vent Painted SurfacesTo clean the inside of the door To clean the outside of the doorLift-Off Oven Door Do not lift the door by the handleOven Light Replacement on some models Oven Heating ElementsOven Shelves To remove the coverTo remove the storage drawer Broiler Pan & GridTo replace the storage drawer Porcelain Enamel Cooktop Lift-Up Cooktop on some modelsSurface Units Drip PansTo remove a surface unit To replace a surface unitInstallation of the range Wiring must conform to National Electric CodesPrepare the Opening Flooring Under the Range Prepare for Electrical ConnectionPower Cord Strain Relief Installation Be installed before reinstalling the rear range wiring coverWire Power Cord Installation Do not remove ground strap connectionBefore After Wire Conduit Installation Local codesConnector block terminal Bare wire Leveling the Range Anti-Tip Bracket InstallationFinal Check Before you call for service… Customer Service Troubleshooting Tips Installation Instructions Operating InstructionsFood does not bake Or roast properlyOven temperature Clock and timerSelf-clean Self-clean cycleOven not clean After a clean cycleClean light To CleanIs on when you Power outageWant to cook A numberCustomer Service GE Electric Range Warranty We Will Replace, At No Charge To YouOne Year From the dateIn-Home Repair Service 800-GE-CARES Service Telephone NumbersTDD 800-TDD-GEAC