GE 164D3333P172 owner manual How to Delay the Start of Cleaning, After a Clean Cycle

Page 21

Latch the door.

How to Delay the Start of Cleaning

(on some models)

1

2 Turn the Oven Temperature knob to CLEAN.

3 Press the START TIME ON/OFF pad.

4 Press the HOUR and MIN. pads to set the time cleaning will start.

When the CLEAN light flashes, slide the latch handle to the left as far as it will go and turn the Oven Temperature knob to OFF.

After a Clean Cycle

You may notice some white ash in the oven. Wipe it up with a damp cloth after the oven cools.

If white spots remain, remove them with a soap-filled steel wool pad and rinse thoroughly with a vinegar and water mixture.

These deposits are usually a salt residue that cannot be removed by the clean cycle.

If the oven is not clean after one clean cycle, repeat the cycle.

■You cannot set the oven for cooking until the oven is cool enough for the door to be unlatched.

■While the oven is self-cleaning, you can press the CLOCK pad to display the time of day. To return to the clean countdown, press the COOK TIME ON/OFF pad.

■If the shelves become hard to slide, wipe the shelf supports with cooking oil.

Safety Information Operating Instructions Installation Instructions Troubleshooting Tips Customer Service

21

Image 21

Contents GE Answer Center GE AppliancesStaple sales slip or cancelled check here Congratulations You Are Now Part of the GE FamilyWrite the model and serial numbers here GE & You Service Partnership All ranges can tip and injury could result Fiberglass insulation in self-clean ovens gives off a veryCalifornia Safe Drinking Water and Toxic Enforcement Cycle. Exposure can be minimized by venting with an openSafety Precautions Safety Information Oven SELF-CLEANING Oven Surface Cooking Units REMEMBER… Customer Service Troubleshooting TipsHow to Set Using the surface unitsSurface Cookware Tips Wok CookingCustomer Service Using the oven controlsOven Control Settings How to Set the Oven for Baking or Roasting Using the ovenBefore you begin… Type of margarine will affect baking performancePreheating and Pan Placement How to Set the Oven for BroilingAluminum Foil Comments Broiling guideUsing the clock and timer Automatic Stop How to Set an Immediate StartMake sure the oven clock shows the correct time of day Press Cook Time ON/OFFFor Models with Pads and an Oven Temperature Knob For Models with Only an Oven Temperature KnobUsing the self-cleaning oven Before a Clean CycleHow to Set the Oven for Cleaning How to Delay the Start of Cleaning After a Clean CyclePress the Start Time ON/OFF pad Control Panel and Knobs Care and cleaning of the rangeOven Vent Painted SurfacesTo clean the outside of the door To clean the inside of the doorLift-Off Oven Door Do not lift the door by the handleOven Heating Elements Oven Light Replacement on some modelsOven Shelves To remove the coverBroiler Pan & Grid To remove the storage drawerTo replace the storage drawer Lift-Up Cooktop on some models Porcelain Enamel CooktopDrip Pans Surface UnitsTo remove a surface unit To replace a surface unitWiring must conform to National Electric Codes Installation of the rangePrepare the Opening Prepare for Electrical Connection Flooring Under the RangeBe installed before reinstalling the rear range wiring cover Power Cord Strain Relief InstallationDo not remove ground strap connection Wire Power Cord InstallationBefore After Local codes Wire Conduit InstallationConnector block terminal Bare wire Anti-Tip Bracket Installation Leveling the RangeFinal Check Before you call for service… Instructions Operating Instructions Customer Service Troubleshooting Tips InstallationFood does not bake Or roast properlyClock and timer Oven temperatureSelf-clean Self-clean cycleAfter a clean cycle Oven not cleanClean light To CleanPower outage Is on when youWant to cook A numberCustomer Service We Will Replace, At No Charge To You GE Electric Range WarrantyOne Year From the dateService Telephone Numbers In-Home Repair Service 800-GE-CARESTDD 800-TDD-GEAC