GE 164D3333P172 owner manual Prepare the Opening

Page 29

Read these instructions completely and carefully.

1 Prepare the Opening

Allow 112″ spacing from the range to adjacent vertical walls above cooktop surface.

Allow 30″ minimum clearance between surface units and bottom of unprotected wood or metal top cabinet, and 15″ minimum between countertop and adjacent cabinet bottom.

EXCEPTION: Installation of a listed microwave oven or cooking appliance over the cooktop shall conform to the installation instructions packed with that appliance.

If cabinet storage is installed, reduce risk by installing a range hood that projects horizontally a min. of 5″ beyond the bottom of the cabinets. Make sure the wall covering, countertops and cabinets around the range can withstand heat generated by the range, oven or cooktop up to 200°F.

Not less than the width of the range

Hood

5Min.

3015Min. Min.

Safety Information Operating Instructions Installation Instructions

Wall

112Min.

Locate the outlet box within either shaded area.

Troubleshooting Tips

Outlet box

Wall

712

C of range

L

7

712

Install the outlet box on either side of the C

L

312

Floor

Cord

5

214

Customer Service

29

Image 29
Contents GE Answer Center GE AppliancesWrite the model and serial numbers here Staple sales slip or cancelled check hereCongratulations You Are Now Part of the GE Family GE & You Service Partnership All ranges can tip and injury could result Fiberglass insulation in self-clean ovens gives off a veryCalifornia Safe Drinking Water and Toxic Enforcement Cycle. Exposure can be minimized by venting with an openSafety Precautions Safety Information Oven SELF-CLEANING Oven Surface Cooking Units REMEMBER… Customer Service Troubleshooting TipsHow to Set Using the surface unitsSurface Cookware Tips Wok CookingCustomer Service Using the oven controlsOven Control Settings How to Set the Oven for Baking or Roasting Using the ovenBefore you begin… Type of margarine will affect baking performanceAluminum Foil Preheating and Pan PlacementHow to Set the Oven for Broiling Comments Broiling guideUsing the clock and timer Automatic Stop How to Set an Immediate StartMake sure the oven clock shows the correct time of day Press Cook Time ON/OFFFor Models with Pads and an Oven Temperature Knob For Models with Only an Oven Temperature KnobHow to Set the Oven for Cleaning Using the self-cleaning ovenBefore a Clean Cycle Press the Start Time ON/OFF pad How to Delay the Start of CleaningAfter a Clean Cycle Control Panel and Knobs Care and cleaning of the rangeOven Vent Painted SurfacesTo clean the outside of the door To clean the inside of the doorLift-Off Oven Door Do not lift the door by the handleOven Heating Elements Oven Light Replacement on some modelsOven Shelves To remove the coverTo replace the storage drawer Broiler Pan & GridTo remove the storage drawer Lift-Up Cooktop on some models Porcelain Enamel CooktopDrip Pans Surface UnitsTo remove a surface unit To replace a surface unitWiring must conform to National Electric Codes Installation of the rangePrepare the Opening Prepare for Electrical Connection Flooring Under the RangeBe installed before reinstalling the rear range wiring cover Power Cord Strain Relief InstallationDo not remove ground strap connection Wire Power Cord InstallationBefore After Local codes Wire Conduit InstallationConnector block terminal Bare wire Final Check Anti-Tip Bracket InstallationLeveling the Range Before you call for service… Instructions Operating Instructions Customer Service Troubleshooting Tips InstallationFood does not bake Or roast properlyClock and timer Oven temperatureSelf-clean Self-clean cycleAfter a clean cycle Oven not cleanClean light To CleanPower outage Is on when youWant to cook A numberCustomer Service We Will Replace, At No Charge To You GE Electric Range WarrantyOne Year From the dateTDD 800-TDD-GEAC Service Telephone NumbersIn-Home Repair Service 800-GE-CARES