GE 164D3333P172 owner manual Care and cleaning of the range, Control Panel and Knobs, Oven Vent

Page 22

Customer Service Troubleshooting Tips Installation Instructions Operating Instructions Safety Information

Care and cleaning of the range.

		If your range is removed for cleaning, servicing
		or any reason, be sure the anti-tip device is
		re-engaged properly when the range is replaced.
		Failure to take this precaution could result in
		tipping of the range and cause injury.


		Control Panel and Knobs
		Control Panel and Knobs
		Clean up spatters with a damp cloth. Remove heavier
		soil with warm, soapy water.
		Do not use abrasives of any kind on the control panel.
		The control knobs may be removed for easier cleaning.
Pull the knob straight off the stem.		The control knobs may be removed for easier cleaning.

To remove a knob, pull it straight off the stem. Wash the knobs in soap and water but do not soak.

Oven Vent

The oven is vented through an opening under the right rear surface unit.

Never cover the opening with aluminum foil or any other material.

Oven vent location

Painted Surfaces

Painted surfaces include the sides and the drawer front.

Clean these with soap and water or a vinegar and water solution.

Do not use commercial oven cleaners, cleaning powders, steel wool or harsh abrasives on any painted surface.

22

Image 22

Contents GE Appliances GE Answer CenterCongratulations You Are Now Part of the GE Family Staple sales slip or cancelled check hereWrite the model and serial numbers here GE & You Service Partnership California Safe Drinking Water and Toxic Enforcement Fiberglass insulation in self-clean ovens gives off a veryAll ranges can tip and injury could result Cycle. Exposure can be minimized by venting with an openSafety Precautions Safety Information Oven SELF-CLEANING Oven Surface Cooking Units Customer Service Troubleshooting Tips REMEMBER…Surface Cookware Tips Using the surface unitsHow to Set Wok CookingUsing the oven controls Customer ServiceOven Control Settings Before you begin… Using the ovenHow to Set the Oven for Baking or Roasting Type of margarine will affect baking performanceHow to Set the Oven for Broiling Preheating and Pan PlacementAluminum Foil Broiling guide CommentsUsing the clock and timer Make sure the oven clock shows the correct time of day How to Set an Immediate StartAutomatic Stop Press Cook Time ON/OFFFor Models with Only an Oven Temperature Knob For Models with Pads and an Oven Temperature KnobBefore a Clean Cycle Using the self-cleaning ovenHow to Set the Oven for Cleaning After a Clean Cycle How to Delay the Start of CleaningPress the Start Time ON/OFF pad Oven Vent Care and cleaning of the rangeControl Panel and Knobs Painted SurfacesLift-Off Oven Door To clean the inside of the doorTo clean the outside of the door Do not lift the door by the handleOven Shelves Oven Light Replacement on some modelsOven Heating Elements To remove the coverTo remove the storage drawer Broiler Pan & GridTo replace the storage drawer Porcelain Enamel Cooktop Lift-Up Cooktop on some modelsTo remove a surface unit Surface UnitsDrip Pans To replace a surface unitInstallation of the range Wiring must conform to National Electric CodesPrepare the Opening Flooring Under the Range Prepare for Electrical ConnectionPower Cord Strain Relief Installation Be installed before reinstalling the rear range wiring coverWire Power Cord Installation Do not remove ground strap connectionBefore After Wire Conduit Installation Local codesConnector block terminal Bare wire Leveling the Range Anti-Tip Bracket InstallationFinal Check Before you call for service… Food does not bake Customer Service Troubleshooting Tips InstallationInstructions Operating Instructions Or roast properlySelf-clean Oven temperatureClock and timer Self-clean cycleClean light Oven not cleanAfter a clean cycle To CleanWant to cook Is on when youPower outage A numberCustomer Service One Year GE Electric Range WarrantyWe Will Replace, At No Charge To You From the dateIn-Home Repair Service 800-GE-CARES Service Telephone NumbersTDD 800-TDD-GEAC