GE 164D3333P172 owner manual For Models with Only an Oven Temperature Knob

Page 19

Adjust the oven thermostat—Do it yourself!

You may find that your new oven cooks differently than the one it replaced. Use your new oven for a few weeks to become more familiar with it. If you still think your new oven is too hot or too cold, you can adjust the thermostat yourself.

Do not use thermometers, such as those found in grocery stores, to check the temperature setting of your oven. These thermometers may vary 20–40 degrees.

NOTE: This adjustment will not affect the broiling or the self-cleaning temperatures. The adjustment will be retained in memory after a power failure.

For Models with Only an Oven Temperature Knob

 

Put the knob in the OFF position.

1

 

Pull the knob off by pulling straight out.

2

 

Press and hold the HOTTER or COOLER button

3

 

for 5 seconds to make the oven 20°F. hotter or

 

20°F. cooler.

 

Replace the knob.

4

When you are adjusting the thermostat, the following lights will flash indicating where the thermostat will be set when you release the adjustment button:

■ OVEN ON: Indicates the thermostat will be set at the factory setting.

■ PREHEATED: Indicates the thermostat will be set 20°F. hotter.

(appearance may vary)

■ CLEAN: Indicates the thermostat will be set 20°F. cooler.

 

For Models with Pads and an Oven Temperature Knob

 

Put the Oven Temperature knob in the OFF position.

1

 

Press and hold the HOUR +/– pads for 5 seconds until

2

 

the display changes.

 

Before display changes back, press the HOUR +/–

3

 

pads to increase or decrease the temperature in

5 degree increments.

The oven temperature can be increased up to 35°F. hotter or can be decreased down to 35°F. cooler.

If the oven adjustment is set cooler than the factory setting a minus sign (–) and the offset temperature will appear in the display.

Safety Information Operating Instructions Installation Instructions Troubleshooting Tips Customer Service

 

Wait several seconds for the control to automatically

 

4

19

 

set and return to its previous setting.

 

Page 18 Page 20
Image 19
Page 18 Page 20
Contents GE Answer Center GE AppliancesCongratulations You Are Now Part of the GE Family Staple sales slip or cancelled check hereWrite the model and serial numbers here GE & You Service Partnership Cycle. Exposure can be minimized by venting with an open Fiberglass insulation in self-clean ovens gives off a veryAll ranges can tip and injury could result California Safe Drinking Water and Toxic EnforcementSafety Precautions Safety Information Oven SELF-CLEANING Oven Surface Cooking Units REMEMBER… Customer Service Troubleshooting TipsWok Cooking Using the surface unitsHow to Set Surface Cookware TipsCustomer Service Using the oven controlsOven Control Settings Type of margarine will affect baking performance Using the ovenHow to Set the Oven for Baking or Roasting Before you begin…How to Set the Oven for Broiling Preheating and Pan PlacementAluminum Foil Comments Broiling guideUsing the clock and timer Press Cook Time ON/OFF How to Set an Immediate StartAutomatic Stop Make sure the oven clock shows the correct time of dayFor Models with Pads and an Oven Temperature Knob For Models with Only an Oven Temperature KnobBefore a Clean Cycle Using the self-cleaning ovenHow to Set the Oven for Cleaning After a Clean Cycle How to Delay the Start of CleaningPress the Start Time ON/OFF pad Painted Surfaces Care and cleaning of the rangeControl Panel and Knobs Oven VentDo not lift the door by the handle To clean the inside of the doorTo clean the outside of the door Lift-Off Oven DoorTo remove the cover Oven Light Replacement on some modelsOven Heating Elements Oven ShelvesTo remove the storage drawer Broiler Pan & GridTo replace the storage drawer Lift-Up Cooktop on some models Porcelain Enamel CooktopTo replace a surface unit Surface UnitsDrip Pans To remove a surface unitWiring must conform to National Electric Codes Installation of the rangePrepare the Opening Prepare for Electrical Connection Flooring Under the RangeBe installed before reinstalling the rear range wiring cover Power Cord Strain Relief InstallationDo not remove ground strap connection Wire Power Cord InstallationBefore After Local codes Wire Conduit InstallationConnector block terminal Bare wire Leveling the Range Anti-Tip Bracket InstallationFinal Check Before you call for service… Or roast properly Customer Service Troubleshooting Tips InstallationInstructions Operating Instructions Food does not bakeSelf-clean cycle Oven temperatureClock and timer Self-cleanTo Clean Oven not cleanAfter a clean cycle Clean lightA number Is on when youPower outage Want to cookCustomer Service From the date GE Electric Range WarrantyWe Will Replace, At No Charge To You One YearIn-Home Repair Service 800-GE-CARES Service Telephone NumbersTDD 800-TDD-GEAC
Top Page Image Contents