GE 164D3333P172 owner manual Anti-Tip Bracket Installation, Leveling the Range, Final Check

Page 36

Customer Service Troubleshooting Tips Installation Instructions Operating Instructions Safety Information

Installation of the range.

Read these instructions completely and carefully.

8 Anti-Tip Bracket Installation

An Anti-Tip bracket is supplied with instructions for installation in a variety of locations. The instructions include a template, a parts list and a list of tools necessary to complete the installation. Read the Important Safety Information and the instructions that fit your situation before beginning installation.

WARNING

■Range must be secured by Anti-Tip bracket supplied.

■See instructions to install (supplied with bracket).

■Unless properly installed, the range could be tipped by stepping or sitting on the door. Injury might result from spilled hot liquids or from the range itself.

Bracket

Wall plate

Screw must enter wood or metal

Typical installation of anti-tip bracket attachment to wall.

9 Leveling the Range

The range must be level. Leveling feet are located at each corner of the base of the range. Remove the storage drawer or kick panel (depending on your model) and using channel locks, rotate the leveling feet in and out as required to level the range. (For instructions on how to remove and replace the storage drawer or the kick panel, see the Care and cleaning of the range section.)

On some models, there are plastic covers which may be removed for easy adjustment (just squeeze and pull).

One of the rear leveling feet will engage the Anti-Tip bracket (allow for some side to side adjustment). Allow a minimum clearance of 1/8″ between the range and the leveling foot that is to be installed into the Anti-Tip bracket.

Check the range for proper installation into the Anti-Tip bracket by removing the kick panel or storage drawer and inspecting the rear leveling leg. Make sure it fits securely into the slot.

10 Final Check

Be sure all range controls are in the OFF position before leaving the

36range.

Image 36

Contents GE Appliances GE Answer CenterStaple sales slip or cancelled check here Congratulations You Are Now Part of the GE FamilyWrite the model and serial numbers here GE & You Service Partnership Fiberglass insulation in self-clean ovens gives off a very All ranges can tip and injury could resultCalifornia Safe Drinking Water and Toxic Enforcement Cycle. Exposure can be minimized by venting with an openSafety Precautions Safety Information Oven SELF-CLEANING Oven Surface Cooking Units Customer Service Troubleshooting Tips REMEMBER…Using the surface units How to SetSurface Cookware Tips Wok CookingUsing the oven controls Customer ServiceOven Control Settings Using the oven How to Set the Oven for Baking or RoastingBefore you begin… Type of margarine will affect baking performancePreheating and Pan Placement How to Set the Oven for BroilingAluminum Foil Broiling guide CommentsUsing the clock and timer How to Set an Immediate Start Automatic StopMake sure the oven clock shows the correct time of day Press Cook Time ON/OFFFor Models with Only an Oven Temperature Knob For Models with Pads and an Oven Temperature KnobUsing the self-cleaning oven Before a Clean CycleHow to Set the Oven for Cleaning How to Delay the Start of Cleaning After a Clean CyclePress the Start Time ON/OFF pad Care and cleaning of the range Control Panel and KnobsOven Vent Painted SurfacesTo clean the inside of the door To clean the outside of the doorLift-Off Oven Door Do not lift the door by the handleOven Light Replacement on some models Oven Heating ElementsOven Shelves To remove the coverBroiler Pan & Grid To remove the storage drawerTo replace the storage drawer Porcelain Enamel Cooktop Lift-Up Cooktop on some modelsSurface Units Drip PansTo remove a surface unit To replace a surface unitInstallation of the range Wiring must conform to National Electric CodesPrepare the Opening Flooring Under the Range Prepare for Electrical ConnectionPower Cord Strain Relief Installation Be installed before reinstalling the rear range wiring coverWire Power Cord Installation Do not remove ground strap connectionBefore After Wire Conduit Installation Local codesConnector block terminal Bare wire Anti-Tip Bracket Installation Leveling the RangeFinal Check Before you call for service… Customer Service Troubleshooting Tips Installation Instructions Operating InstructionsFood does not bake Or roast properlyOven temperature Clock and timerSelf-clean Self-clean cycleOven not clean After a clean cycleClean light To CleanIs on when you Power outageWant to cook A numberCustomer Service GE Electric Range Warranty We Will Replace, At No Charge To YouOne Year From the dateService Telephone Numbers In-Home Repair Service 800-GE-CARESTDD 800-TDD-GEAC