GE 10-95 CG warranty Important Safety Instructions

Page 3

IMPORTANT SAFETY INSTRUCTIONS

Read all instructions before using this appliance.

IMPORTANT SAFETY NOTICE

•The California Safe Drinking Water and Toxic Enforcement Act requires the Governor of California to publish a list of substances known to the state to cause birth defects or other reproductive harm, and requires businesses to warn customers of potential exposure to such substances.

•The fiberglass insulation in self-clean ovens gives off a very small amount of carbon monoxide during the cleaning cycle. Exposure can be minimized by venting with an open window or using a ventilation fan or hood.

•Fluorescent light bulbs contain mercury. If your model has a surface light, you must recycle the fluorescent light bulb according to local, state and federal codes.

When using electrical appliances, basic safety precautions should be followed, including the following:

•Use this appliance only for its intended use as described in this guide.

•Be sure your appliance is properly installed and grounded by a qualified technician in accordance with the provided installation instructions.

•Do not attempt to repair or replace any part of your range unless it is specifically recommended in this guide. All other servicing should be referred to a qualified technician.

•Before performing any service, DISCONNECT THE RANGE POWER SUPPLY AT THE HOUSEHOLD DISTRIBUTION PANEL

BY REMOVING THE FUSE OR SWITCHING OFF THE CIRCUIT BREAKER.

WARNING—

All ranges can tip and injury could result. To prevent accidental tipping of the range, attach it to the wall and floor by installing the Anti-Tip device supplied.

To check if the device is installed and engaged properly, remove the storage drawer and inspect the rear leveling leg. Make sure it fits securely into the slot.

If you pull the range out from the wall for any reason, make sure the device is properly engaged when you push the range back against the wall. If it is not, there is a possible risk of the range tipping over and causing injury if you or a child stand, sit or lean on an open door.

Please refer to the Anti-Tip device information in this guide. Failure to take this precaution could result in tipping of the range and injury.

•Do not leave children alone—children should not be left alone or unattended in an area where an appliance is in use. They should never be allowed to sit or stand on any part of the appliance.

•Do not allow anyone to climb, stand or hang on the door, drawer or cooktop. They could damage the range and even tip it over, causing severe personal injury.

•CAUTION: ITEMS OF INTEREST TO CHILDREN SHOULD NOT BE STORED IN CABINETS ABOVE A RANGE OR ON THE BACKSPLASH OF A RANGE—CHILDREN CLIMBING ON THE RANGE TO REACH ITEMS COULD BE SERIOUSLY INJURED.

•Do not store flammable materials in an oven or near the cooktop.

•Never wear loose-fitting or hanging garments while using the appliance. Be careful when reaching for items stored in cabinets over the range. Flammable material could be ignited if brought in contact with hot surface units or heating elements and may cause severe burns.

• Use only dry pot holders—moist or

damp pot holders on hot surfaces may result in burns from steam. Do not let

pot holders touch hot surface units or heating elements. Do not use a towel or other bulky cloth.

(continued next page)

3

Important Safety Instructions

Page 2 Page 4
Image 3
Page 2 Page 4
Contents UseandCare& Installation Guide Save time and money. Before you request service… Help US Help YOU…If you received Damaged range… Important Safety Instructions Important Safety InstructionsOven Self-Cleaning OvenCooktop and Radiant Surface Units Save These InstructionsJBP79 Features of Your RangeFeatures of Your Range Type of Cooktop Description How It Works Radiant HOW does this Cooktop Compare To Your OLD ONE?General Information About Radiant Surface Units Cooktop ComparisonSurface Controls How to Set the ControlsDual Surface Unit Switch Cooking Guide for Using Heat SettingsHot Surface Indicator Light Surface ControlsSpecial Notes for Glass Cooktops Porcelain/enamel Surface Cookware TipsTypes of Cookware Copper BottomHow to Check Pan Performance SurfaceResistant, not scratch proof Flat-bottomed canners are required for glass cooktops Home Canning TipsObserve the Following Points in Canning Canning should be done on the cooktop onlyHome Canning Tips Glass Cooktop CleaningCleaning Glass Cooktop CleaningBroil Bake Features of Your Oven ControlOven Control Oven CONTROL, Clock and TimerFeatures of Your Clock and TimerShelf Positions Using Your OvenBefore Using Your Oven Oven ShelvesBaking UsingBaking Your OvenCookies Pan PlacementBaking Pans Baking GuidesDon’t Peek How to Time BakeHow to Set Immediate Start and Automatic Stop Timed BakingQuick Reminder How to Set Delay Start and Automatic StopTimed Baking Adjust the Oven Thermostat Adjust the Oven ThermostatUse of Aluminum Foil RoastingFor Frozen Roasts Questions and AnswersWhy is my roast crumbling when I try to carve it? Roasting GuideWhy are my meats not turning out as brown as they should? BroilingShould I salt the meat before broiling? Broiling Guide BroilingOven door should be open to the broil stop position Before a Clean Cycle Operating the SELF-CLEANING OvenTo Stop a Clean Cycle Cleaning OvenHow to Set the Oven for Cleaning After a Clean CycleHow to Set Delay Start of Cleaning Care and Cleaning Operating the Self-Cleaning OvenCare Glass Window Control Panel and KnobsCooktop Surface Light Metal PartsOven Heating Elements Care and CleaningLift-Off Oven Door Sure Grip HandleAfter broiling, remove How to Remove the Storage Drawer to Clean Under the RangeOven Light Replacement Broiler Pan and GridBefore YOU Begin Installation InstructionsStep Step Wire Power Cord Installation Step Wire Conduit Installation Step Final Check Problem Possible Cause QUESTIONS? USE this Problem SolverAfter Clean Cycle Problem SolverIf YOU Need Service Problem SolverNeed Problem Solver If YouService ServicesWarranty

10-95 CG specifications

The GE 10-95 CG is a notable locomotive designed to meet the demands of freight transport with efficiency and reliability. Built by General Electric, this model showcases a combination of advanced technology and impressive engineering, making it a prominent choice in the rail industry.

One of the primary features of the GE 10-95 CG is its powerful diesel engine. The locomotive is equipped with a 12-cylinder 7FDL engine, capable of producing substantial horsepower that allows it to handle heavy loads across challenging terrains. This engine configuration not only provides reliability but also ensures operational efficiency, allowing for lower fuel consumption over longer distances.

The 10-95 CG is recognized for its distinct, rugged design that is built to withstand diverse environmental conditions. Its robust frame and sturdy body contribute to its longevity and durability, while the optimized aerodynamics reduce drag, enhancing fuel efficiency. The locomotive's structure is designed for easy access and maintenance, allowing operators to keep it in optimal working condition with minimal downtime.

In terms of technologies, the GE 10-95 CG integrates advanced electronic systems that enhance performance and monitoring. The locomotive features a sophisticated microprocessor-based control system that enables precise engine management, ensuring optimal operation under varying conditions. Additionally, the use of dynamic braking technology provides enhanced control, reducing wear and tear on the braking system while improving safety.

The traction system of the GE 10-95 CG employs alternating current (AC) traction motors, which are known for their efficiency and reduced maintenance requirements compared to traditional DC motors. This technology results in better acceleration and overall performance, making the locomotive adept in both hauling heavy freight and navigating tight curves.

Another notable characteristic of the GE 10-95 CG is its ability to operate in multiple unit configurations. This allows for seamless coupling with other locomotives, enabling operators to scale their freight capacity as needed. The versatility of this locomotive makes it a valuable asset in various rail operations.

In summary, the GE 10-95 CG embodies a blend of power, efficiency, and advanced technology. With features designed for durability, operational efficiency, and ease of maintenance, it stands out as a formidable choice for freight transportation in the rail industry. Its innovative systems and robust performance characteristics ensure that it remains a reliable solution for meeting the demands of modern logistics and transportation.
Top Page Image Contents