I.TO REMOVE ELECTRODES (LHR, CF, RHR, RHF BURNERS)
1.Isolate from electric supply.
2.Proceed as ‘TO REMOVE THE HOTPLATE’.
3.Proceed as ‘TO REMOVE SPARK GENERATOR’ disconnect the appropriate electrode lead.
4.Withdraw clip securing electrode to burner and withdraw lead and electrode (See Fig. 29).
5.
Fig. 29 | DESN 511649 |
|
|
J.TO REMOVE ELECTRODES (LHF AND CR BURNER)
1.Isolate from electrical supply.
2.Proceed as ‘TO REMOVE HOTPLATE’.
3.Proceed as ‘TO REMOVE SPARK GENERATOR’.
4.Disconnect burner pipe (1/2”) and remove screws (2) fixing burner to support (Fig. 30).
5.Turn burner over and remove electrode fixing clip (Fig. 31). Remove spring and withdraw electrode through top of burner checking on route of lead.
6.
Fig. 30 | DESN 512921 |
|
|
56