E.TO REMOVE GAS TAPS/IGNITION SWITCHES
1.Isolate from electric and gas supply.
2.Proceed as ‘TO REMOVE HOTPLATE’.
3.Disconnect gas rail feed pipe (19mm nut). (See Fig. 28)
4.Disconnect all gas connections to taps.
LH side 5 nuts (5/16”, 9/16” and 3/4”). RH side 4 nuts (9/16” and 3/4”)
5.Remove (10) screws fixing gas rail support panel and gas rail.
6.Disconnect ignition switch cables. Lift away inner facia and move clear, do not stress wires on thermostats. (See Fig. 28).
NOTE: Take care to identify cable terminations.
7.Lift complete gas rail assembly clear of appliance.
8.Remove bolts (2) and clamp fixing to gas rail and withdraw tap from gas rail
NOTE: ENSURE A NEW TAP SEAL IS USED WHEN REPLACING THE TAPS.
9.Remove clip on tap spindle, then remove spring, washer and ignition switch. Ensure new switch is fitted with tab towards tap. (See Fig. 28A).
10.
Fig. 28 | DESN 512918 |
|
|
Fig. 28A | DESN 512918 |
54