Broan HEPA 1000, HEPA 4000, HEPA 3000, HEPA 2000 installation instructions VD0088

Page 31

5. CONTROLS (CONT’D)

5.4INSTALLATION OF THE OPTIONAL WALL CONTROLS

(CONTROLS C12 / CM AND C34 / CMR) (CONT’D)

8.Using a small rod, pierce a hole through the unit at the end of the wire channel. (See picture beside.) Splice back the end of the cable to access the 4 wires. Remove the insulated sleeve of each wire ends. Insert the end of the cable through the unit, using the small hole previously done.

VD0088

9.In order to access the unit PCB terminals, remove the side door located on the electrical box and punch out its knock

out. Run the cable through the knock-out

 

hole and connect each wire in their

 

corresponding terminal (YELLOW in

 

‘’Y’’, RED in ‘’R’’, GREEN in ‘’G’’and

 

BLACK in ‘’B’’).

 

NOTE: Push forward slightly on the

 

little tabs (1) to ease insertion

 

of each wires.

 

See picture beside.

VE0049

1

10.Reinstall the side door on the electrical box and the 8’’ oval port on the unit.

11.Route the wire through its channel and reinstall the front panel on the unit. See picture beside.

VD0089

12.If the installation is not completed, return to Section 4 on page 19. If the installation is completed, plug the unit.

NOTE: When using an optional wall control, the main switch on the unit must always be positioned to NORMAL/REMOTE.

- 31 -

Page 30 Page 32
Image 31
Page 30 Page 32
Contents Installation Instructions About this Manual About These Units Table of Contents Table DES Matières Before Starting Typical InstallationsTypical Installations CONT’D Hepa 1000 and HF 1.0 Unit Installations CONT’D RETURN-RETURN Installation Connection to a Forced AIR System Hepa 4000 Restricted Area VH0051 Hepa 2000, HF 2.0, Hepa 3000, HF 3.0 and Hepa Hepa 2000, HF 2.0, Hepa 3000, HF 3.0 and Hepa 4000 Unit VH0043 Front View TOP View DimensionsDimensions CONT’D Install the Unit Install the Unit CONT’D HOW to Hang the Unit CONT’D Stale air exhaust ductwork Stale air ductwork Filtered air ductwork Return side connection cont’d Hepa 2000, HF2.0, Hepa 3000, HF 3.0 and Hepa 4000 Units only Pull back the insulation to expose the flexible duct 457 mm Xmas tree pin Connecting the Drain Hepa 3000 and HF 3.0 Units only NORMAL/REMOTE ControlsControls C12 / CM and C34 / CMR Controls CONT’DControls C12 / CM and C34 / CMR CONT’D VD0088 Is on Normal or Boost Using C34 / CMR Control Maintenance For Hepa 2000 and HF 2.0 only Maintenance CONT’DMaster Reset C12 / CM and C34 / CMR Controls Parts Ordering Chart Problems Solutions Troubleshooting
Top Page Image Contents