Broan HEPA 4000, HEPA 3000, HEPA 2000, HEPA 1000 installation instructions Is on Normal or Boost

Page 32

5. CONTROLS (CONT’D)

5.5OPERATING C12 / CM CONTROL

5.5.1 C12 / CM CONTROL DESCRIPTION

POWER INDICATOR:

LIGHTS UP WHEN SLIDE SWITCH

IS ON NORMAL OR BOOST

POSITION.

FILTER MAINTENANCE

INDICATOR:

FLASHES EVERY MINUTE TO

INDICATE IT IS ON DUTY.

FLASHES EVERY SECOND WHEN

ITS TIME TO REPLACE

PREFILTER. SEE BIANNUAL

VC0054

BOOST:

UNIT IS OPERATING ON

HIGH SPEED.

NORMAL:

UNIT IS OPERATING ON

NORMAL SPEED.

OFF:

UNIT IS OFF.

MAINTENANCE IN SECTION 6.

LIGHTS UP WHEN ITS TIME TO

REPLACE FILTER AND

PREFILTER. SEE ANNUAL

MAINTENANCE IN SECTION 6.

RESET FILTER HOLE:

ONCE THE MAINTENANCE DONE, RESET THE FILTER

MAINTENANCE INDICATOR BY CAREFULLY INSERTING

A SMALL ROD (EG: PAPER CLIP) IN THE RESET FILTER

HOLE, DURING 1 SECOND. THE FILTER MAINTENANCE

INDICATOR WILL TURN OFF.

5.5.2USING C12 / CM CONTROL

•OFF: To stop the unit, slide the button on this position.

•NORMAL: For a day-to-day usage, slide the button on this position. The unit then will operate on normal speed.

•BOOST: For a high speed operation, slide the button on this position. Generally used when extreme conditions occur, eg.: parties, smokers, etc.

- 32 -

Image 32

Contents Installation Instructions About this Manual About These Units Table of Contents Table DES Matières Typical Installations Before StartingTypical Installations CONT’D Hepa 1000 and HF 1.0 Unit Installations CONT’D RETURN-RETURN Installation Connection to a Forced AIR System Hepa 4000 Restricted Area VH0051 Hepa 2000, HF 2.0, Hepa 3000, HF 3.0 and Hepa Hepa 2000, HF 2.0, Hepa 3000, HF 3.0 and Hepa 4000 Unit VH0043 Dimensions Front View TOP ViewDimensions CONT’D Install the Unit Install the Unit CONT’D HOW to Hang the Unit CONT’D Stale air exhaust ductwork Stale air ductwork Filtered air ductwork Return side connection cont’d Hepa 2000, HF2.0, Hepa 3000, HF 3.0 and Hepa 4000 Units only Pull back the insulation to expose the flexible duct 457 mm Xmas tree pin Connecting the Drain Hepa 3000 and HF 3.0 Units only Controls NORMAL/REMOTEControls CONT’D Controls C12 / CM and C34 / CMRControls C12 / CM and C34 / CMR CONT’D VD0088 Is on Normal or Boost Using C34 / CMR Control Maintenance Maintenance CONT’D For Hepa 2000 and HF 2.0 onlyMaster Reset C12 / CM and C34 / CMR Controls Parts Ordering Chart Troubleshooting Problems Solutions