Broan HEPA 2000, HEPA 4000, HEPA 3000, HEPA 1000 installation instructions Xmas tree pin

Page 26

4.INSTALL THE UNIT (CONT’D)

4.7INSTALLING DUAL EXTERIOR HOOD

(HEPA 2000, HF 2.0, HEPA 3000, HF 3.0 AND HEPA 4000 UNITS ONLY) (CONT’D)

4.7.3CONNECTING TANDEM® TRANSITION TO EXTERIOR DUAL HOOD (CONT’D)

2.Joint the end of the Tandem® transition to the rear of the exterior backplate. Secure with 2 Xmas tree pins and seal properly with duct tape.

Xmas tree pin

VD0085

CAUTION

The exterior backplate must be installed with the word ‘’TOP’’ pointing upward.

3.Lean the exterior backplate to the exterior wall.Using 4 #8 x 1 1/2”screws, fix it to the wall. Seal the outline with caulking.

VD0086

4.Snap the assembled exterior hood on its backplate and secure with 2 provided screws (#8 x 3/4” long).

VD0087

screw

- 26 -

Image 26

Contents Installation Instructions About this Manual About These Units Table of Contents Table DES Matières Typical Installations Before StartingTypical Installations CONT’D Hepa 1000 and HF 1.0 Unit Installations CONT’D RETURN-RETURN Installation Connection to a Forced AIR System Hepa 4000 Restricted Area VH0051 Hepa 2000, HF 2.0, Hepa 3000, HF 3.0 and Hepa Hepa 2000, HF 2.0, Hepa 3000, HF 3.0 and Hepa 4000 Unit VH0043 Dimensions Front View TOP ViewDimensions CONT’D Install the Unit Install the Unit CONT’D HOW to Hang the Unit CONT’D Stale air exhaust ductwork Stale air ductwork Filtered air ductwork Return side connection cont’d Hepa 2000, HF2.0, Hepa 3000, HF 3.0 and Hepa 4000 Units only Pull back the insulation to expose the flexible duct 457 mm Xmas tree pin Connecting the Drain Hepa 3000 and HF 3.0 Units only Controls NORMAL/REMOTEControls CONT’D Controls C12 / CM and C34 / CMRControls C12 / CM and C34 / CMR CONT’D VD0088 Is on Normal or Boost Using C34 / CMR Control Maintenance Maintenance CONT’D For Hepa 2000 and HF 2.0 onlyMaster Reset C12 / CM and C34 / CMR Controls Parts Ordering Chart Troubleshooting Problems Solutions