| Transition Networks |
Connecting fiber cables
Fiber cable When connecting fiber cables to the
installation sure the correct type is used: ST or SC.
To install the fiber cables, do the following:
Step | Action |
1.Remove and keep the rubber
Note: When not connected to a fiber cable, insert the rubber protective cover into optic port to protect the optics.
2.
Check that the fiber terminators are clean. If necessary, clean the fiber connectors using locally accepted cleaning procedures.
Note: Dirty fiber connectors on fiber optic cables will impair light transmission quality through the cable and lead to degraded performance on the port.
3.
Connect the fiber cable as shown in Figure 11.
Figure 11: Fiber Cable Connections
4.
Check the corresponding fiber port LED on the Device Server to verify the
Warning
•Visible and invisible laser radiation when open: DO NOT stare into the beam, or directly view the beam with optical instruments. Failure to observe this warning could result in an eye injury or blindness.
•Use of controls, adjustments or the performance of procedures other than those specified herein may result in hazardous radiation exposure.
17 |