Kenmore 790.7755 manual Cleaning and removing double burner parts, Changing Oven Lights

Page 39

General Care & Cleaning

Cleaning and removing double ring burners (some models)

Changing Oven Light(s)

Cleaning and removing double burner parts

To remove for cleaning (see fig. 1):

1.Remove burner grate (not illustrated) and inner burner head.

2.Burner skirt.

3.Outer burner head.

4.Lift and remove brass distribution block.

To clean:

The ports around the burner heads should be routinely cleaned. Use soap & water. Thoroughly dry before reassembling. If residue still remains in these ports, use a small gauge wire or needle to clean them. For proper flow of the gas and the burner ignition ALWAYS keep the burner heads in place whenever the burners are in use.

To replace:

Align brass distribution block pin with burner base (see fig. 2) and carefully place block on top of burner base-Do not force. Be sure distribution block is level.

Align notch on outer burner head with slot (see fig. 3) on top of the brass distribu- tion block-Do not force. Be sure outer burner head is level.

Replace burner skirt and inner burner head.

1.Inner burner head

2.Burner skirt

 

3.Outer

 

burner

 

head

........k

4.Brass

....,

distribution

......... >'_

block

I

 

iii...........

Burner base

Fig. 1

Fig. 2

Fig. 3

Changing Oven Lights

The oven lights automatically turn ON when the door is opened. The oven lights may also be manually operated by pressing

the d,O,'-_pad. The oven light bulbs are located at the rear of the oven and are covered with a glass shield held by a wire

v

holder. The glass shields must be in place whenever the oven is in use.

Be sure the range is unplugged and all parts are COOL before replacing oven light. Weara leather-faced glove for protection against possible broken glass.

Wir_

Holder

To replace the oven light bulb(s):

1.Turn electrical power off at the main source or unplug the range.

2.Press wire holder to one side to release the glass shield.

3.Replace bulb with a new 40 watt appliance bulb.

4.Replace glass shield over bulb and snap wire holder into place.

5.Turn power back on again at the main source (or plug the range back in).

6.The clock will then need to be reset. To reset, see Setting the Clock and Timer in this Use & Care Guide.

39

Image 39
Contents Fuel .an e Contents Whatto do iF YOU Smell GAS Do not try to light any appliance Important Safety instructionsYour Cooktop Important Instructions for Using Your OvenImportant Safety Notice Grounding iNSTRUCTiONSIMPORTANT Notice En los EE.UU Unlimited service and no charge for parts and laborAnnual Preventive Maintenance Check at your U.S.AYour Dual Fuel Range Features include Range FeaturesTypes of Oven Racks Before Setting Oven ControlsOven Vent Location Removing & Replacing Oven RacksControl Locations ControlsBaking Layer Cakes with 1 or 2 Oven Racks Air Circulation in the OvenOperating the Double Ring Burner Surface CookingOperating the Gas Surface Burners Double Ring BurnerArranging Warmer Warm & Ready TM Drawer Rack Positions Care & Seasoning of the Griddle optional accessoryUsing the Griddle Using the Warmer DrawerSetting Warmer Drawer Controls To Set the Warmer Drawer & Bread Proofing ControlsWarmer Drawer Food Drawer Preparing Bread Dough for the Warmer DrawerTo Remove and Replace Warmer Warm & Ready TM Drawer Removing and replacing the warmer Warm & Ready TMElectronic Oven Control Pad Features Read the iNSTRUCTiONS Carefully Before Using the OVEN. ForMinimum & Maximum Press Display Setting Oven ControlsSetting the Clock Setting Silent Control OperationTo cancel the Timer before the set time has run out Setting Continuous Bake or 12 Hour Energy SavingSetting Timer To set the Timer example for 5 minutesPress Setting Oven Lockout Feature LockoutTo activate the Oven Lockout feature Setting Temperature Display m Fahrenheit or CelsiusTo quickly erase all stored recipes To Set the Recipe Recall FeatureInstructions Press Display To recall the cookie recipe stored underthe B. keyTo set the Preheat temperature for 350F Setting PreheatTo set the Bake Temperature to 350F Setting BakeBake at 350F for 50 minutes Setting Cook TimeSetting Delay Start Instructionspress To set the oven to broil at the default setting 550FRoasting Rack Instructions Optional AccessoryProper Meat Probe placement Using and Setting Meat ProbeTo use the Meat Probe Using and Setting the Meat Probe contdConvection Tips for Convection BakeTo set the oven for Convection Bake To Set Add 1 Minute Feature To set the Convection Convert featureSetting the Slow Cook Feature PressdisplayOptional Setting the Sabbath Day Feature Setting the Warm & Hold TM Feature To set Warm & HoldTo set Warm & Hold to turn on automatically Self-Cleaning Oven Self=CleaningThru 400 using When the Self-Clean cycle is doneStopping or Interrupting a Self-Cleaning cycle Self= CleaningAdjusting Oven Temperature To adjust the oven temperature higherTo adjust the oven temperature lower Surfaces How to Clean General Care & CleaningCare & Cleaning of Stainless Steel some models Removing & Replacing the Lift-OffOven DoorDoor Care Instructions Fig. I Cooktop burner head Cleaning the Cooktop well areas, burner caps & burner headsCleaning and removing double burner parts To remove for cleaning see figChanging Oven Lights Before You Call Possible CAUSE/SOLUTIONOccurrence You r Home