Kenmore 790.99012 manual Oven Lights, Removing and Replacing Warmer Warm & Ready TM Drawer

Page 34

General Care & Cleaning

FEATURE OVERVIEW

•Removing & Replacing Warmer Drawer

Removing and Replacing Warmer (Warm & Ready TM) Drawer

[]

Pull up with finger

To Remove Warmer Drawer:

 

 

Left Glide

1. _

Turn power off before removing the warmer drawer.

2.Open the drawer to the fully opened position.

3.Locate glide lever on each side of drawer, pull up on the left glide lever and push down on the right glide lever (See Figure 1).

5.Pull the drawer away from the range.

Figure 1

Figure 2

To Replace Warmer (Warm & Ready TM) Drawer:

1.Pull the bearing glides to the front of the chassis glide (See Figure 2).

2.Align the glide on each side of the drawer with the glide slots on the range.

3.Push the drawer into the range until levers "click" (approximately 2"). Pull the drawer open again to seat bearing glides into position. If you do not hear the levers "click" or the bearing glides do not feel seated remove the drawer and repeat steps 1 thru 3. This will minimize possible damage to the bearing glides.

NOTE: The Warmer Drawer will NOT operate while inthe "Self-Clean" and "Oven Lockout" modes

 

in serious injury or death. Disconnect appliance from electric

'_

"! 'vA'f-'1't[€11Electricalll

Shock Hazard can occur and result

 

power before cleaning and servicing the warmer drawer.

Oven Lights

FEATURE OVERVIEW

•Operating Oven Lights

•Replacing Oven Light

Be sure the range is unplugged and all parts are COOL before replacing oven light(s). Wear a leather-faced glove for protection against possible broken glass.

To Operate the Oven Lights

Both of the interior oven lights automatically turn on when the oven

door is opened. Press _

to turn the lights ON and OFF when the

oven door is closed. Each oven light is located at the rear wall of the oven interior and is covered with a glass shield held by a wire holder (See Figure 3). The Glass Shields must be in place whenever the oven is in use.

Wire

Holder

Figure 3

To Replace the Oven Light:

1.Turn electrical power off at the main source and unplug the range.

2.Press Wire Holder to one side to release the glass shield.

3.Replace the old bulb with a new 40 watt appliance bulb.

4.Replace Glass Shield over bulb and snap Wire Holder into place.

5.Turn power back on again at the main source (or plug in the range).

6.The clock will then need to be reset. To reset, see Setting the Clock in this Use & Care Guide.

34

Page 33 Page 35
Image 34
Page 33 Page 35
Contents Electric Range Estufa Electrica ModelsContents Important Safety Instructions Self Cleaning Ovens Important Instructions for Using Your CooktopImportant Instructions for Using Your Oven Important Instructions for Cleaning Your RangeProduct Record Serial Plate LocationRadiantElement IndicatorLight Colorwillvaryby modelBddgl Dual Surface BroilPan InsertHtfront Setting Surface ControlsFeature Overview About the Ceramic Glass CooktopSurface Cooking Settings Esec Lockout Feature Esec Hot Element Indicator Message HEEsec Error Indicator Message Er Operating Single Radiant Surface ElementsTo Operate the Dual Surface Element Operating the Dual Surface Radiant ElementBridge Surface Radiant Element Curvedandwarpedpan bottoms To Operate the Bridge Surface ElementPanissmallerthan Surface Cooking TemperatureOperating the Warmer Warm & Ready TM Zone Arranging Oven Racks Before Setting Oven ControlsAir Circulation in the Oven Recommended Rack Positions For Broiling Baking & RoastingDrawer Controls Temperature SelectionWarmer Drawer Indicator Light Arranging Warmer Warm & Ready TM Drawer Rack PositionsPad Settings Control Pad FeaturesMinimum and Maximum Control Setting the Clock Instructions Press DisplayTo set the control Kitchen TimerPress Display Bake HourInstructions Consumer Defined Control FeaturesSetting Oven Lockout Feature PressdisplaySetting Silent Control Operation Stop Time @ Clean Defined Control FeaturesFor 7seconds To set the Preheat temperature for 350F Setting Oven ControlsSetting Preheat PreheatSetting Bake To set the Bake Temperature to 350FBake Oven Cook Time Setting Timed BakeWhen the timed bake time runs out Times each minute untilWhen the set bake time runs out Setting Delayed Time BakeInstructionspress To set the oven to broil at the default setting 550F Broiling Times and Searing GrillCakes Breads Foods to be Cooked in each Setting the Food Categories FeaturesRecommended CategoryBenefits of Convection Bake Setting Convection BakeTo set the oven for Convection Bake Temperature to 350F General Convection Bake InstructionsPreparing for the Self-Clean Cycle Adhere to the following cleaning precautionsTo Start the Self-Clean Cycle Stopping or Interrupting a Self-Cleaning CycleTo Start the Delayed Self-Clean Cycle QQQTo adjust the oven temperature higher Adjusting Oven TemperatureTo adjust Oven temperature Lower Surfaces How to Clean Stai nless Steel, Ch tom eFor light to moderate soil Cleaning Recommendations for the Ceramic Glass CooktopPlastic or foods with a high sugar content For heavy, burned on soilTo Remove Oven Door Do not use the following on the ceramic glass cooktopRemoving and Replacing the Oven Door To Replace Oven DoorTo Operate the Oven Lights Oven LightsRemoving and Replacing Warmer Warm & Ready TM Drawer To Replace the Oven LightSolutions to Common Problems Possible CAUSE/SOLUTIONOccurrence Esec displays - message Cooking Tables Foods for Convection Bake pad *Decrease Normal cook time byRib Roast w/Gravy contd Apple Bourbon Pie contd LE-FOYER Mc MY-HOMEP.m. Sat SU-HOGAR sM
Top Page Image Contents