Sterling sse manual For the operating safety of the equipment

Page 16

Machine-Side Hopper Loaders

2.2. For the operating safety of the equipment

Never change settings if the consequences are not precisely known.

Use only original manufacturer-approved spare parts.

Please observe the maintenance schedule.

Keep record of all maintenance and repair work.

Please note that electronic components may be damaged by static discharge.

Check all electrical connections for proper fit before the equipment operated for the first time and at regular intervals.

The operating temperature range is 32 to +113 °F (0 °C to +45 °C).

The recommended storage temperature range is -13 to +131 °F (-25 °C and +55 °C). Write down all data that you have entered into the control system.

Please ensure that all plugs are correctly plugged in.

The operating instructions of the connected machines must be followed.

Operate the device only if all its components are grounded.

Never adjust sensors without exact knowledge of their function.

Please note that a compressed air supply is required for the operation of the active cleaning option.

Compressed air supply for the active cleaning option should not exceed 87 PSI (6 bar) (active cleaning option only).

Align the suction tubes correctly.

The unit should be installed in such a way that the outlet flap swings at right angles to the moving direction of the equipment.

The load-bearing capacity of the machine flange should be adhered to.

A level indicator is required when conveying from granulators.

Safety instructions 2-5

Image 16

Contents Operating Instructions Machine-Side Hopper Loader SSE Series Machine-Side Hopper Loaders Iii Machine-Side Hopper Loaders Parts and Service Department Table of Contents Accessories 11-1 Electrical manual 12-1 General instructions Machine-Side Hopper Loaders Legal basis Explanations and informationFields of applications Page Safety instructions For your safety GeneralAssembly Maintenance OperationFor the operating safety of the equipment Page Transport, assembly and storage Transport and packing AssemblyStorage Assembly instructions Unpacking Liter modelInstalling the dump valve sensor Dump valve and sensorAttaching the pickup wand Mounting MountingMounting on the processing machine Mounting onto a machine hopperMounting onto mixing hoppers with lateral inlet Mounting onto DT 30 dosing stationElectrical connection Compressed air connectionInstallation of the optional proportioning valve X7, ZKWConnecting Material Lines Functional description Sequence of operation ControllerOperation Switching on the unit Checking the flexible hoseSetting the conveying time Setting the purge time optional Switching off the unit Initial operationPage Troubleshooting Alarms Maintenance Machine-Side Hopper Loaders Maintenance intervals Servicing the loader Changing the sealing ring of the outlet flapAdjusting the dump valve sensor Cleaning the unit Order numbers Filter cloth Wire cloth Installation Replacing carbon brushes at the motorMachine-Side Hopper Loaders Taking out of service, dismantling, disposal Disposal InstructionsTechnical data Specifications Liter model Brushless motor Loader Capacity Dimension Sheet Liter model Liter brushless model Spare parts list Parts breakdown, brush-type motor Parts lists, 2-liter model 10.2.1 V, 50 Hz10.2.2 V, 60 Hz 10.2.3 V, 50 Hz with active cleaning 10.2.4 V, 60 Hz with active cleaningParts list, 5-liter model 10.3.1 V, 50 Hz V6637210.3.2 V, 60 Hz V66378US Pos. Order no. Designation10.3.3 V, 50 Hz with active cleaning 10.3.4 V, 60 Hz with active cleaningParts breakdown and list, 5-liter model with brushless motor 10.5 V, 50 Hz Accessories Page Electrical manual Page Page Page Page Page Page Page Page Page Setting the loader convey time Quick Start Guide