Sterling sse manual Alarms

Page 39

Machine-Side Hopper Loaders

7.1. Alarms

An alarm will be triggered if there is no material to convey or if the loader overheats.

&An “E” appears in the display and an error number. And alarm will sound.

FDo not restart operation until the malfunction has been corrected. The following error messages can be displayed:

“E1"

The alarm message “E1" is displayed when no material has been conveyed during 3 consecutive conveying cycles.

•Check that sufficient material is being conveyed.

•Check that the flap switch is set correctly.

As supplied, this feature is disabled. To enable it:

1.Turn the loader off and remove power.

2.Remove the cover from the control.

3.Remove the two wires that are connected to terminals X9 and X6

4.Replace the cover and turn the loader on.

“E2"

If the control system becomes too hot during operation (>158°F, 70°C) the “E2" alarm message is displayed and the unit is switched off.

•Allow the system to cool before restarting.

&When the malfunction has been corrected, turn the power off and then on again to restart.

7-2 Troubleshooting

Image 39

Contents Operating Instructions Machine-Side Hopper Loader SSE Series Machine-Side Hopper Loaders Iii Machine-Side Hopper Loaders Parts and Service Department Table of Contents Accessories 11-1 Electrical manual 12-1 General instructions Machine-Side Hopper Loaders Explanations and information Legal basisFields of applications Page Safety instructions General For your safetyAssembly Operation MaintenanceFor the operating safety of the equipment Page Transport, assembly and storage Assembly Transport and packingStorage Assembly instructions Liter model UnpackingDump valve and sensor Installing the dump valve sensorAttaching the pickup wand Mounting MountingMounting onto a machine hopper Mounting on the processing machineMounting onto DT 30 dosing station Mounting onto mixing hoppers with lateral inletCompressed air connection Electrical connectionX7, ZKW Installation of the optional proportioning valveConnecting Material Lines Functional description Controller Sequence of operationOperation Checking the flexible hose Switching on the unitSetting the conveying time Setting the purge time optional Initial operation Switching off the unitPage Troubleshooting Alarms Maintenance Machine-Side Hopper Loaders Maintenance intervals Changing the sealing ring of the outlet flap Servicing the loaderAdjusting the dump valve sensor Cleaning the unit Order numbers Filter cloth Wire cloth Replacing carbon brushes at the motor InstallationMachine-Side Hopper Loaders Disposal Instructions Taking out of service, dismantling, disposalTechnical data Specifications Liter model Brushless motor Loader Capacity Dimension Sheet Liter model Liter brushless model Spare parts list Parts breakdown, brush-type motor 10.2.1 V, 50 Hz Parts lists, 2-liter model10.2.2 V, 60 Hz 10.2.4 V, 60 Hz with active cleaning 10.2.3 V, 50 Hz with active cleaning10.3.1 V, 50 Hz V66372 Parts list, 5-liter modelPos. Order no. Designation 10.3.2 V, 60 Hz V66378US10.3.4 V, 60 Hz with active cleaning 10.3.3 V, 50 Hz with active cleaningParts breakdown and list, 5-liter model with brushless motor 10.5 V, 50 Hz Accessories Page Electrical manual Page Page Page Page Page Page Page Page Page Quick Start Guide Setting the loader convey time