Sterling sse manual Installation of the optional proportioning valve, X7, ZKW

Page 28

Machine-Side Hopper Loaders

4.7. Installation of the optional proportioning valve

&Before proceeding, review the connecting diagram included with the unit.

For more information, refer to the manual that shipped with the proportioning valve.

Connecting the proportioning valve:

Control and power of the proportioning valve is supplied through a 4-wire control connection.

Brown	–	Positive Power	X7, L
Blue	–	Negative power	X7, N
Black	–	Line signal	X7, ZKW
Green w/ Yellow	–	Ground	X3

1.Remove the control box face, and locate the removable plug in the bottom of the box.

2.Remove the plug and feed the wire of the proportioning valve through the empty hole.

3.Tighten the lock nut inside, position the wire length for optimum use and tighten the lock nut on the outside.

4.Strip the wires so that 1/4” of wire is showing, for connection to terminal blocks.

5.Upon removal of the loader control face you will see two printed circuit boards. One board on the reverse of the control face, and the other mounted inside the control box. The ground wire will connect to the terminal block X3 on the back of the control face. The other three wires connect to terminal block X7 inside the control box, in order from left to right Brown, Blue, then Black. Please refer to the schematic in the back of the manual.

Assembly instructions 4-9

Image 28

Contents Operating Instructions Machine-Side Hopper Loader SSE Series Machine-Side Hopper Loaders Iii Machine-Side Hopper Loaders Parts and Service Department Table of Contents Accessories 11-1 Electrical manual 12-1 General instructions Machine-Side Hopper Loaders Legal basis Explanations and informationFields of applications Page Safety instructions For your safety GeneralAssembly Maintenance OperationFor the operating safety of the equipment Page Transport, assembly and storage Transport and packing AssemblyStorage Assembly instructions Unpacking Liter modelInstalling the dump valve sensor Dump valve and sensorAttaching the pickup wand Mounting MountingMounting on the processing machine Mounting onto a machine hopperMounting onto mixing hoppers with lateral inlet Mounting onto DT 30 dosing stationElectrical connection Compressed air connectionInstallation of the optional proportioning valve X7, ZKWConnecting Material Lines Functional description Sequence of operation ControllerOperation Switching on the unit Checking the flexible hoseSetting the conveying time Setting the purge time optional Switching off the unit Initial operationPage Troubleshooting Alarms Maintenance Machine-Side Hopper Loaders Maintenance intervals Servicing the loader Changing the sealing ring of the outlet flapAdjusting the dump valve sensor Cleaning the unit Order numbers Filter cloth Wire cloth Installation Replacing carbon brushes at the motorMachine-Side Hopper Loaders Taking out of service, dismantling, disposal Disposal InstructionsTechnical data Specifications Liter model Brushless motor Loader Capacity Dimension Sheet Liter model Liter brushless model Spare parts list Parts breakdown, brush-type motor Parts lists, 2-liter model 10.2.1 V, 50 Hz10.2.2 V, 60 Hz 10.2.3 V, 50 Hz with active cleaning 10.2.4 V, 60 Hz with active cleaningParts list, 5-liter model 10.3.1 V, 50 Hz V6637210.3.2 V, 60 Hz V66378US Pos. Order no. Designation10.3.3 V, 50 Hz with active cleaning 10.3.4 V, 60 Hz with active cleaningParts breakdown and list, 5-liter model with brushless motor 10.5 V, 50 Hz Accessories Page Electrical manual Page Page Page Page Page Page Page Page Page Setting the loader convey time Quick Start Guide