Sterling sse Mounting onto mixing hoppers with lateral inlet, Mounting onto DT 30 dosing station

Page 26

Machine-Side Hopper Loaders

4.4.3. Mounting onto mixing hoppers with lateral inlet

A VT Series adapter is required to mount the loader on a mixing hopper with a laterial inlet. Two-liter models require a VT 1.0 adapter. Five- liter models require a VT 2.3/70 or VT 2.8/70 adapter. Use the following procedure to mount the loader to the mixing hopper:

1.	Mount the adapter onto the swan-neck of
	the mixing hopper.	Figure 8: VT Adapter
		Figure 8: VT Adapter
2.	Mount the loader onto the adapter.

FObserve the bearing capacity of the machine flange.

4.4.4. Mounting onto DT 30 dosing station

Two-liter loaders mount directly onto the DT 30 Dosing Station. Five-liter models require an AD 1/5 adapter.

Two Liter Models:

1.Mount the dosing hopper directly onto the dosing container of the dosing station DT 30.

2. Mount the loader onto the dosing hopper.	Figure 9: DT 30

FObserve the bearing capacity of the machine flange.

Five Liter Models:

1.Mount the adapter piece directly onto the dosing container of the dosing station DT 30.

2.Mount the loader onto the adapter piece.

F Figure 10: AD 1/5

Observe the bearing capacity of the machine flange.

Assembly instructions 4-7

Image 26

Contents Operating Instructions Machine-Side Hopper Loader SSE Series Machine-Side Hopper Loaders Iii Machine-Side Hopper Loaders Parts and Service Department Table of Contents Accessories 11-1 Electrical manual 12-1 General instructions Machine-Side Hopper Loaders Fields of applications Explanations and informationLegal basis Page Safety instructions For your safety GeneralAssembly Maintenance OperationFor the operating safety of the equipment Page Transport, assembly and storage Storage AssemblyTransport and packing Assembly instructions Unpacking Liter modelInstalling the dump valve sensor Dump valve and sensorAttaching the pickup wand Mounting MountingMounting on the processing machine Mounting onto a machine hopperMounting onto mixing hoppers with lateral inlet Mounting onto DT 30 dosing stationElectrical connection Compressed air connectionInstallation of the optional proportioning valve X7, ZKWConnecting Material Lines Functional description Sequence of operation ControllerOperation Switching on the unit Checking the flexible hoseSetting the conveying time Setting the purge time optional Switching off the unit Initial operationPage Troubleshooting Alarms Maintenance Machine-Side Hopper Loaders Maintenance intervals Servicing the loader Changing the sealing ring of the outlet flapAdjusting the dump valve sensor Cleaning the unit Order numbers Filter cloth Wire cloth Installation Replacing carbon brushes at the motorMachine-Side Hopper Loaders Taking out of service, dismantling, disposal Disposal InstructionsTechnical data Specifications Liter model Brushless motor Loader Capacity Dimension Sheet Liter model Liter brushless model Spare parts list Parts breakdown, brush-type motor Parts lists, 2-liter model 10.2.1 V, 50 Hz10.2.2 V, 60 Hz 10.2.3 V, 50 Hz with active cleaning 10.2.4 V, 60 Hz with active cleaningParts list, 5-liter model 10.3.1 V, 50 Hz V6637210.3.2 V, 60 Hz V66378US Pos. Order no. Designation10.3.3 V, 50 Hz with active cleaning 10.3.4 V, 60 Hz with active cleaningParts breakdown and list, 5-liter model with brushless motor 10.5 V, 50 Hz Accessories Page Electrical manual Page Page Page Page Page Page Page Page Page Setting the loader convey time Quick Start Guide