Shindaiwa DH212, 82053 manual Starting warm engine, Stopping engine

Page 14

ENGLISH

Starting warm engine

The starting procedure is the same as Cold Start except DO NOT close the choke.

WARNING

The blades must not move at idle, otherwise serious personal injury may result. Periodic carburetor adjustment may be necessary to as- sure blades do not move at idle.

If blades move, readjust carburetor according to “Carburetor Ad- justment” instructions in this manual or see your Shindaiwa Dealer.

1.Stop Switch

Move stop switch (A) away from the STOP position.

2.Purge Bulb

Pump purge bulb (C) until fuel is visible and flows freely in the clear fuel tank return line. Pump bulb an additional 4 or 5 times.

3.Recoil Starter

Place the unit on a flat, clear area. Grip the front handle securely with one hand, and pull the recoil starter handle (D) until engine starts.

NOTE

If engine does not start after 5 pulls, use Cold Start Procedure.

A

C

D

Stopping engine

1.

Throttle

 

 

Release throttle and allow engine to return to idle before shutting off

A

 

engine.

 

2.

Stop Switch

 

 

Move stop switch (A) to STOP position.

 

WARNING

If engine does not stop when stop switch is moved to STOP position, close choke - COLD START position - to stall engine. Have your Shindaiwa dealer repair stop switch before using hedge trimmer again.

14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents DH212 Hedge Trimmer Operator’s manual Table of ContentsIntroduction Personal condition and safety equipment Safety Manual safety symbols and important informationInternational symbols Hand Protection Physical ConditionEye Protection Hearing ProtectionClear the Work Area Repetitive Stress InjuriesRead the Manuals Keep a Firm GripEmission Control EPA Phase 2/ C.A.R.B. TierEquipment check Product Emission DurabilityRight Front Handle Guard DescriptionEnglish Contents AssemblyInstall blade stiffener Blade stiffener removalFuel Fuel RequirementsOperation Fuel to Oil Mix-501 Ratio Handling FuelAfter use MetricStarting cold engine Purge BulbStarting warm engine Stopping engineSkill levels MaintenanceHedge trimming Maintenance intervals Do-It-Yourself Maintenance ProceduresLevel Air filterFuel filter Remaining sand will damage engine Spark plugCooling system English Exhaust system Spark Arrestor ScreenCylinder Exhaust Port High Altitude Operation Carburetor adjustmentEngine Break-In Lubrication Gear Box AssemblyBlades Sharpening blades Blade adjustment Troubleshooting Long Term Storage over 30 days StorageSpecifications Model DH212What does this Warranty COVER? Manufacturers Warranty CoverageOwners Warranty Responsibilities HOW will a Covered Part be CORRECTED?English English English Shindaiwa Inc Shindaiwa Corporation 11975 S.W. Herman Rd Cortadora DE Setos DH212 Tabla de materias IntroducciónEl manual del operador ImportanteSímbolos internacionales Forma de los SímbolosProtección de las manos Condición físicaProtección de los ojos Protección de los oídosDespeje el área de trabajo Lesiones debidas a esfuerzos repetitivosLea los manuales Agarre bien la unidadControl de emisiones Fase 2 de EPA / Nivel III de C.A.R.BEquipos Durabilidad DE LAS Emisiones DEL ProductoDescripción Cerca del silenciadorSP8 Nota ContenidoMontajeo Nota Instale el refuerzo de la hojaDesmontaje del refuerzo de hoja Combustible Requisitos del combustibleOperación Manipulación del combustible Instrucciones de mezclaArranque del motor en frío CebadorArranque con el motor caliente Parada del motorNiveles de habilidad Recorte de setosMantenimiento ¡IMPORTANTEIntervalos de mantenimiento Procedimientos De Mantenimiento De Do-It-YourselfNivel Filtro de aireFiltro de combustible Bujía Sistema de enfriamientoSP19 Sistema de escape Rejilla del apagachispasOrificio de escape del cilindro Ajuste del carburador Rodaje del motorAjuste de altitud elevada ImportanteLubricación HojasConjunto de la caja de engranajes Afilado de las hojas Ajuste de la hoja Localización y reparación de fallas Almacenamiento a largo plazo más de 30 días AlmacenamientoEspecificaciones Modelo HC-150Relacionados CON Emisiones EPA Phase 2 / California Relacionados CON LAS Emisiones EPA PhaseCalifornia Tier III Emissions Defect Warranty EN Piezas Cubiertas POR LA Garantía Contra DefectosNotas SP30 SP31 Shindaiwa Inc Shindaiwa Corporation TAILLE-HAIE DH212 Le manuel d’utilisation Table des matièresCondition physique et équipement de sécurité Sécurité Symboles de sécurité et informations importantesSymboles internationaux Protection des mains Condition physiqueProtection des yeux Protection auditiveDégagez la zone de travail Microtraumatismes répétésLisez les manuels Garder une bonne priseContrôle des émissions EPA Phase 2 / C.A.R.B. TierÉquipement Durabilité DU Contrôle DES ÉmissionsGarde de poignée avant droite Autocollant de danger de Brûlures près du silencieuxFR8 Remarque ContenuAssemblage Installation du raidisseur de lame Retrait du raidisseur de lameCarburant Spécifications pour le carburantUtilisation Après utilisation Manipulation du carburantInstructions de mélange RemisageDémarrage d’un moteur froid RemarqueDémarrage d’un moteur chaud Arrêt du moteurTaille EntretienNiveaux de difficulté Intervalles d’entretienNiveau Filtre à airFiltre à carburant Bougie Système de refroidissementRetirer l’écran de chaleur C du couvercle du silencieux Systéme déchappement Pare-étincellesLumière d’échappement du cylindre Reglage du carburateur Rodage du moteurRéglage pour haute altitude Lubrification LamesAssemblage du carter d’engrenages Affûtage des lames Ajustement de lame Dépannage Remisage à long terme plus de 30 jours RemisageCaractéristiques Modèle DH212CE QUE Couvre Cette Garantie Couverture DE LA Garantie DES FabricantsResponsabilités DU Propriétaire À L’ÉGARD DE LA Garantie EN CAS DE Pièce DéfectueuseRemarques FR30 FR31

82053, DH212 specifications

The Shindaiwa 82053, DH212 is a powerful and versatile tool designed for professionals in the landscaping and horticultural industries. Known for its robust performance and reliability, this product stands out among its peers due to several innovative features and technologies tailored to meet the needs of demanding users.

One of the main highlights of the Shindaiwa 82053 is its powerful engine. This tool is equipped with a high-performance engine that delivers exceptional cutting power while maintaining fuel efficiency. The engine's design minimizes vibration and ensures smooth operation, allowing users to work effectively without excessive fatigue.

The DH212, a key component of the Shindaiwa 82053, is recognized for its ergonomic design. This feature enhances user comfort during extended periods of operation. The handles are thoughtfully designed to provide superior grip and control, reducing the strain on the operator's hands and arms. This is particularly important for professionals who often work long hours.

Another significant characteristic of the Shindaiwa 82053 is its advanced cutting technology. The dual-edge blade system provides a cleaner and faster cut, allowing for efficient trimming of hedges and bushes. The blades are crafted from high-quality materials that ensure durability and longevity, even under heavy use.

The tool's rapid-start feature is designed to reduce startup time, enabling users to get to work quickly without unnecessary delays. Additionally, the advanced air filtration system helps to keep the engine clean, extending its lifespan and improving reliability.

The Shindaiwa 82053, DH212 is also known for its easy maintenance. The design incorporates accessible components, allowing users to perform routine checks and repairs with minimal hassle. This user-friendly approach reduces downtime and enhances productivity.

In terms of safety, the Shindaiwa 82053 features multiple safeguards that protect the user during operation. The protective guards and blade covers ensure that operators can work confidently without the fear of accidental injuries.

Overall, the Shindaiwa 82053, DH212 embodies a perfect blend of power, comfort, and advanced technology, making it an ideal choice for professional landscapers and gardeners. Its exceptional performance and reliability are sure to make it a trusted tool in any landscaping arsenal. Whether trimming hedges or maintaining gardens, the Shindaiwa 82053 is a dependable ally that ensures work is completed efficiently and effectively.
Top Page Image Contents