Servis-Rhino P/N 00763618C manual Maintenance, Lubrication Information

Page 102

MAINTENANCE

MAINTENANCE

Before operating your Mower, make sure it is properly lubricated and thoroughy inspected. Only a minimum of time and effort is required to regularly lubricate and maintain this machine to provide long life and trouble free operation.

WARNING! Always disengage the PTO before raising the mower for transporting or making adjustments.

LUBRICATION INFORMATION

Do not let excess grease collect on or around parts, particulary when operating in sandy areas. The illustrations below shows lubrication points. All points should be lubricated daily under normal operating conditions. Severe or unusual conditions may require more frequent lubrication. Figure 1.

Use an SAE multi-purpose, lithium-type grease for all locations shown. Be sure to clean the fitting thoroughly before using grease gun. Daily lubrication of the wing driveline slip joint is necessary. Failure to maintain proper lubrication will result in damage to U-joints, gearbox, and/or driveshaft.

		FIGURE 1
Turf Flex 08-01	Maintenance Section 5-2	R 11-3-95
	Maintenance Section 5-2	R 11-3-95
© 2004 Alamo Group Inc.

Image 102

Contents Turf Flex To the OWNER/OPERATOR/DEALER Safety Training Makes the Difference Page Table of Contents Page Safety Section Peligro ¡LEA ELInstructivo Safety Safety Following rules Serious injury or death. SG-26 Safety With the windows closed. SGM-11 Stop Mowing if Passersby are Within 100 Yards Unless Wait a minute...Save a life Parts Information See Your SERVIS-RHINO Dealer12 3A 3536 QTY Level Description PeligroSafety D103 Turf Flex 08/01 Safety Section 04-23-99 00763535 Turf Flex Name D102 Safety Federal Laws and Regulations Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Introduction Section Introduction Introduction Before Operating this Machine Assembly Section Assembly Dealer SET-UP InstructionsSwivel and Lift ARM Attachment Hydraulic Cylinder Attachment Wing Mower AttachmentCaster Wheel Attachments Rear Mower Figure Caster Wheel Attachments Wing Mower Figure Caster Wheel Attachments Rear Mower 11 ModelCaster Wheel Attachments Wing Mower 11 Model Figure Rear Mower AttachmentAxle Arms in Postion Assembly Spool Valve Driveshaft AttachmentHydraulic Hose Attachment SMV AttachmentWing Driveshaft Attachment Left Wing Driveline Right Wing DrivelineRope Routing for Automatic Head Locks Assembly Page Operation Section Tractor Preparation Attaching Cutter to TractorSafety Chains Pull Type Cutting Height Adjustment Roller AdjustmentDriveline Attachment to Tractor Starting & Stopping Mower Cutting SpeedMowing Tips Driveline Length Check Procedure Before Operating or Transporting this MowerSpecial Instructions for Rough Terrain Operations Transporting Cutter CV Driveline Check Procedures DEGProblem Possible Cause Remedy StreakingFrayed Edges on Page Maintenance Section Maintenance Lubrication InformationGearbox Center 4-WAY Gear BOXSwivel Assembly Gauge Wheel AssembliesBlade Spindle Lubrication Driveline Lubrication CV Driveline Profile LubricationWing Driveline Profile Lubrication Blade Sharpening Blade InstallationBlade Servicing Blade RemovalBelt Adjustment Procedure All Models except Belt Adjustment Procedure 11 Model Belt Installation 11 ModelStorage Proper Torque for FastenersMaintenance Tool Turf Flex Maintenance Section 12-13-95 Page To the OWNER/OPERATOR/DEALER TURFFLEX-OMWPL-08/01