Servis-Rhino P/N 00763618C manual Special Instructions for Rough Terrain Operations

OPERATION

With the PTO NOT TURNING, slowly drive the tractor with mower attached through sharpest turn possible and watch shaft movement.

With PTO NOT TURNING, slowly drive the tractor with mower attached through the most severe terrain conditions expected and watch Shaft movement.

Check position which places driveline at maximum extended length and at maximum compressed length. Maximum extended length must always maintain at least 10 inches of profile tube engagement. Maximum compressed length should always maintain 1-9/16 clearance; if not shorten driveline as shown in Fig 8.

If driveline cannot be shortened and still maintain 10 inches of tube engagement then the operator should note test so he can recognize the terrain conditions that might cause the problem and avoid possible dam- age by disconnecting driveline from tractor.

1-9/16

FIGURE 8

SPECIAL INSTRUCTIONS FOR ROUGH TERRAIN OPERATIONS

When crossing ditches with steep banks or going up sharp inclines, it is possible to “bottom out” the Driveline that connects the tractor PTO to the Gearbox on mower.

Note: To bottom out means that the Inner Shaft has penetrated into the Outer Housing to its maximum depth until the Assembly becomes solid - it can shorten no more. See Figure 9.

If this happens, it can cause serious damage to the tractor PTO by pushing the PTO into the tractor and through the Support Bearings or downward onto the PTO Shaft, breaking it off.

Driveline bottom out.

FIGURE 9

WARNING! Either failure can allow the Driveline to come loose from the tractor which could cause bodily injury to the operator or others in the vicinity along with expensive damage to the tractor and/or Cutter.

Turf Flex 08-01	Operation Section 4-7
© 2004 Alamo Group Inc.

OPERATION