Servis-Rhino P/N 00763618C manual Safety Federal Laws and Regulations

Page 25

SAFETY

FEDERAL LAWS AND REGULATIONS

This section is intended to explain in broad terms the concept and effect of federal laws and regulations concerning employer and employee equipment operators. This section is not intended as a legal interpretation of the law and should not be considered as such.

Employer-Employee Operator Regulations

U.S. Public Law 91-596 (The Williams-Steiger Occupational and Health Act of 1970) OSHA

This Act Seeks:

“...to assure so far as possible every working man and woman in the nation safe and healthful working conditions and to preserve our human resources...”

DUTIES

Sec. 5 (a) Each employer-

(1)shall furnish to each of his employees employment and a place of employment which are free from recognized hazards that are causing or are likely to cause death or serious physical harm to his employees;

(2)shall comply with occupational safety and health standards promulgated under this Act.

(b)Each employee shall comply with occupational safety and health standards and all rules, regulations and orders issued pursuant to this Act which are applicable to his own actions and conduct.

OSHA Regulations

OSHA regulations state in part: “At the time of initial assignment and at least annually thereafter, the employer shall instruct every employee in the safe operation and servicing of all equipment with which the employee is, or will be involved.”

Employer Responsibilities:

To ensure employee safety during Tractor and Implement operation, it is the employer’s responsibility to:

1.Train the employee in the proper and safe operation of the Tractor and Implement.

2.Require that the employee read and fully understand the Tractor and Implement Operator’s manual.

3.Permit only qualified and properly trained employees to operate the Tractor and Implement.

4.Maintain the Tractor and Implement in a safe operational condition and maintain all shields and guards on the equipment.

5.Ensure the Tractor is equipped with a functional ROPS and seat belt and require that the employee operator securely fasten the safety belt and operate with the ROPS in the raised position at all times.

6.Forbid the employee operator to carry additional riders on the Tractor or Implement.

7.Provide the required tools to maintain the Tractor and Implement in a good safe working condition and provide the necessary support devices to secure the equipment safely while performing repairs and service.

8.Require that the employee operator stop mowing if bystanders or passerbys come within 100 yards.

Child Labor Under 16 Years of Age

Some regulations specify that no one under the age of 16 may operate power machinery. It is your responsibility to know what these regulations are in your own area or situation. (Refer to U.S. Dept. of Labor, Employment Standard Administration, Wage & Home Division, Child Labor Bulletin #102.)

Turf Flex 08/01

Safety Section 1-19

© 2004 Alamo Group Inc.

 

SAFETY

Image 25
Contents Turf Flex To the OWNER/OPERATOR/DEALER Safety Training Makes the Difference Page Table of Contents Page Safety Section ¡LEA EL PeligroInstructivo Safety Safety Following rules Serious injury or death. SG-26 Safety With the windows closed. SGM-11 Stop Mowing if Passersby are Within 100 Yards Unless Wait a minute...Save a life See Your SERVIS-RHINO Dealer Parts Information12 3A 3536 Peligro QTY Level DescriptionSafety D103 Turf Flex 08/01 Safety Section 04-23-99 00763535 Turf Flex Name D102 Safety Federal Laws and Regulations Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Introduction Section Introduction Introduction Before Operating this Machine Assembly Section Dealer SET-UP Instructions AssemblySwivel and Lift ARM Attachment Wing Mower Attachment Hydraulic Cylinder AttachmentCaster Wheel Attachments Rear Mower Figure Caster Wheel Attachments Rear Mower 11 Model Caster Wheel Attachments Wing Mower FigureRear Mower Attachment Caster Wheel Attachments Wing Mower 11 Model FigureAxle Arms in Postion Assembly Hydraulic Hose Attachment Driveshaft AttachmentSpool Valve SMV AttachmentLeft Wing Driveline Right Wing Driveline Wing Driveshaft AttachmentRope Routing for Automatic Head Locks Assembly Page Operation Section Attaching Cutter to Tractor Tractor PreparationSafety Chains Pull Type Roller Adjustment Cutting Height AdjustmentDriveline Attachment to Tractor Cutting Speed Starting & Stopping MowerMowing Tips Before Operating or Transporting this Mower Driveline Length Check ProcedureSpecial Instructions for Rough Terrain Operations Transporting Cutter DEG CV Driveline Check ProceduresStreaking Problem Possible Cause RemedyFrayed Edges on Page Maintenance Section Lubrication Information MaintenanceCenter 4-WAY Gear BOX GearboxGauge Wheel Assemblies Swivel AssemblyBlade Spindle Lubrication CV Driveline Profile Lubrication Driveline LubricationWing Driveline Profile Lubrication Blade Servicing Blade InstallationBlade Sharpening Blade RemovalBelt Adjustment Procedure All Models except Belt Installation 11 Model Belt Adjustment Procedure 11 ModelProper Torque for Fasteners StorageMaintenance Tool Turf Flex Maintenance Section 12-13-95 Page To the OWNER/OPERATOR/DEALER TURFFLEX-OMWPL-08/01