Servis-Rhino P/N 00763618C manual Wait a minute...Save a life

Page 16
(SPT-1)

SAFETY

SAFETY

WARNING!

DANGER!

Never leave Tractor and Implemented unattended while the implement is in the lifted position. Accidental operation of lifting lever or a hydraulic failure may cause sudden drop of unit with injury or death by crushing. To properly park the implement when disconnecting it from the tractor, lower the stand and put the retaining pin securely in place, or put a secure support under the A-Frame. Lower the implement carefully to the ground. Do not put hands or feet under lifted components.

Always disconnect the main PTO Driveline from the Tractor before performing service on the Mower. Never work on the Mower with the tractor PTO driveline connected and running. Blades or Drivelines could turn without warning and cause immediate entanglement, injury or death.

(SRM-3)

DANGER!

Make sure the PTO shield, integral driveline shields, and input shields are

 

is installed when using PTO-driven equipment. Always replace any

 

shield if it is damaged or missing. (S3PT-8)

 

WARNING!

Relieve hydraulic pressure prior to doing any maintenance or repair work

 

on the Implement. Place the Implement on the ground or securely

 

blocked up, disengage the PTO, and turn off the tractor engine. Push

 

and pull the Remote Cylinder lever in and out several times prior to

 

starting any maintenance or repair work. (S3PT-9)

 

WARNING!

The rotating parts of this machine continue to rotate even after the PTO

 

has been turned off. The operator should remain in his seat for 60

 

seconds after the brake has been set, the PTO disengaged, the tractor

 

turned off, and all evidence of rotation has ceased.

(3PT-10)

 

“Wait a minute...Save a life!”

WARNING!

Only tow the Implement behind a properly sized and equipped Tractor which exceeds the weight

 

of the Implement by at least 20%. DO NOT tow the Implement behind a truck or other type of

 

vehicle. Never tow the Implement and another Implement connected in tandem. Never tow the

 

Implement at speeds over 20 MPH. (STI-6)

DANGER!

Replace bent or broken blade with new blades. NEVER ATTEMPT TO STRAIGHTEN OR WELD

 

ON BLADES SINCE THIS WILL LIKELY CRACK OR OTHERWISE DAMAGE THE BLADE

 

WITH SUBSEQUENT FAILURE AND POSSIBLE SERIOUS INJURY FROM THROWN BLADES.

 

(SGM-10)

Turf Flex 08/01

Safety Section 1-10

© 2004 Alamo Group Inc.

 

Image 16
Contents Turf Flex To the OWNER/OPERATOR/DEALER Safety Training Makes the Difference Page Table of Contents Page Safety Section ¡LEA EL PeligroInstructivo Safety Safety Following rules Serious injury or death. SG-26 Safety With the windows closed. SGM-11 Stop Mowing if Passersby are Within 100 Yards Unless Wait a minute...Save a life Parts Information See Your SERVIS-RHINO Dealer12 3A 3536 QTY Level Description PeligroSafety D103 Turf Flex 08/01 Safety Section 04-23-99 00763535 Turf Flex Name D102 Safety Federal Laws and Regulations Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Introduction Section Introduction Introduction Before Operating this Machine Assembly Section Assembly Dealer SET-UP InstructionsSwivel and Lift ARM Attachment Hydraulic Cylinder Attachment Wing Mower AttachmentCaster Wheel Attachments Rear Mower Figure Caster Wheel Attachments Wing Mower Figure Caster Wheel Attachments Rear Mower 11 ModelCaster Wheel Attachments Wing Mower 11 Model Figure Rear Mower AttachmentAxle Arms in Postion Assembly Driveshaft Attachment Hydraulic Hose AttachmentSpool Valve SMV AttachmentWing Driveshaft Attachment Left Wing Driveline Right Wing DrivelineRope Routing for Automatic Head Locks Assembly Page Operation Section Tractor Preparation Attaching Cutter to TractorSafety Chains Pull Type Roller Adjustment Cutting Height AdjustmentDriveline Attachment to Tractor Cutting Speed Starting & Stopping MowerMowing Tips Driveline Length Check Procedure Before Operating or Transporting this MowerSpecial Instructions for Rough Terrain Operations Transporting Cutter CV Driveline Check Procedures DEGProblem Possible Cause Remedy StreakingFrayed Edges on Page Maintenance Section Maintenance Lubrication InformationGearbox Center 4-WAY Gear BOXGauge Wheel Assemblies Swivel AssemblyBlade Spindle Lubrication CV Driveline Profile Lubrication Driveline LubricationWing Driveline Profile Lubrication Blade Installation Blade ServicingBlade Sharpening Blade RemovalBelt Adjustment Procedure All Models except Belt Adjustment Procedure 11 Model Belt Installation 11 ModelStorage Proper Torque for FastenersMaintenance Tool Turf Flex Maintenance Section 12-13-95 Page To the OWNER/OPERATOR/DEALER TURFFLEX-OMWPL-08/01