Servis-Rhino P/N 00763618C manual Safety

Page 9
(SG-8)
(SG-6)
(SG-5)
(SG-4)

SAFETY

DANGER! Never operate the Tractor or Implement until you have read and completely understand this Manual, the Tractor Operator’s Manual, and each of the Safety Messages found in the Manual or on the Tractor and Implement. Learn how to stop the tractor engine suddenly in an emergency. Never allow inexperienced or untrained personnel too operate the Tractor and Implement without supervision. Make sure the operator has fully read and understood the manuals prior to operation.

SAFETY

WARNING!

WARNING!

Always maintain the safety decals in good readable condition. If the decals are missing, damaged, or unreadable, obtain and install replace- ment decals immediately.

Make certain that the “Slow Moving Vehicle” (SMV) sign is installed in such a way as to be clearly visible and legible. When transporting the Equipment use the Tractor flashing warning lights and follow all local traffic regulations.

WARNING! Operate this Equipment only with a Tractor equipped with an approved roll-over-protective system (ROPS). Always wear seat belts. Serious injury or even death could result from falling off the tractor--particularly during a turnover when the operator could be pinned under the ROPS.

(SG-7)

WARNING! Do not modify or alter this Implement. Do not permit anyone to modify or alter this Implement, any of its components or any Implement function.

DANGER! BEFORE leaving the tractor seat, always engage the brake and/or set the tractor transmission in parking gear, disengage the PTO, stop the engine, remove the key, and wait for all moving parts to stop. Place the tractor shift lever into a low range or parking gear to prevent the tractor from rolling. Never dismount a Tractor that is moving or while the engine is running. Operate the Tractor controls from the tractor seat only.

(SG-9)

DANGER! Never allow children or other persons to ride on the Tractor or Implement.

Falling off can result in serious injury or death.

(SG-10)

DANGER! Never allow children to operate or ride on the Tractor or Implement.

(SGM-11)

WARNING!

Do not mount the Tractor while the tractor is moving. Mount the Tractor

 

only when the Tractor and all moving parts are completely stopped.

 

 

(SG-12)

Turf Flex

08/01

Safety Section 1-3

© 2004 Alamo Group Inc.

 

Image 9
Contents Turf Flex To the OWNER/OPERATOR/DEALER Safety Training Makes the Difference Page Table of Contents Page Safety Section Peligro ¡LEA ELInstructivo Safety Safety Following rules Serious injury or death. SG-26 Safety With the windows closed. SGM-11 Stop Mowing if Passersby are Within 100 Yards Unless Wait a minute...Save a life See Your SERVIS-RHINO Dealer Parts Information12 3A 3536 Peligro QTY Level DescriptionSafety D103 Turf Flex 08/01 Safety Section 04-23-99 00763535 Turf Flex Name D102 Safety Federal Laws and Regulations Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Introduction Section Introduction Introduction Before Operating this Machine Assembly Section Dealer SET-UP Instructions AssemblySwivel and Lift ARM Attachment Wing Mower Attachment Hydraulic Cylinder AttachmentCaster Wheel Attachments Rear Mower Figure Caster Wheel Attachments Rear Mower 11 Model Caster Wheel Attachments Wing Mower FigureRear Mower Attachment Caster Wheel Attachments Wing Mower 11 Model FigureAxle Arms in Postion Assembly Hydraulic Hose Attachment Driveshaft AttachmentSpool Valve SMV AttachmentLeft Wing Driveline Right Wing Driveline Wing Driveshaft AttachmentRope Routing for Automatic Head Locks Assembly Page Operation Section Attaching Cutter to Tractor Tractor PreparationSafety Chains Pull Type Cutting Height Adjustment Roller AdjustmentDriveline Attachment to Tractor Starting & Stopping Mower Cutting SpeedMowing Tips Before Operating or Transporting this Mower Driveline Length Check ProcedureSpecial Instructions for Rough Terrain Operations Transporting Cutter DEG CV Driveline Check ProceduresStreaking Problem Possible Cause RemedyFrayed Edges on Page Maintenance Section Lubrication Information MaintenanceCenter 4-WAY Gear BOX GearboxSwivel Assembly Gauge Wheel AssembliesBlade Spindle Lubrication Driveline Lubrication CV Driveline Profile LubricationWing Driveline Profile Lubrication Blade Servicing Blade InstallationBlade Sharpening Blade RemovalBelt Adjustment Procedure All Models except Belt Installation 11 Model Belt Adjustment Procedure 11 ModelProper Torque for Fasteners StorageMaintenance Tool Turf Flex Maintenance Section 12-13-95 Page To the OWNER/OPERATOR/DEALER TURFFLEX-OMWPL-08/01