Servis-Rhino P/N 00763618C manual Safety Chains Pull Type

Page 91

OPERATION

NOTE: If attaching Mower Clevis, tractor drawbar must extend to rear to allow turning without binding in the Tongue Clevis. DO NOT USE THIS TYPE DRAWBAR WITHOUT STABILIZERS. Install washers the same as detailed previously. See art below.

DRAWBAR EXTENSION

TRACTOR

LOWER

LINKS

CONTACT HERE	DRAWBAR
WILL CAUSE
IMMEDIATE
TONGUE OR CLEVIS
FAILURE

ALLOWS AMPLE

TURNING CLEARANCE

STABILIZERS

FIGURE 2

NOTE: NEVER ATTACH MOWER TO TRACTOR WITH A PIN NOT HAVING A NUT.

The two halves of the Clevis must be bolted together securely to carry the load properly without springing or breaking the Clevis.

DANGER! Failure to adjust the Drawbar to the CORRECT LENGTH, failure to PROVIDE DRAWBAR CLEARANCE sufficient for short turns, and/or failure to ATTACH CLEVIS TO THE DRAWBAR correctly and securely MAY ALLOW THE MOWER TO SEPARATE FROM THE TRACTOR AND/OR THE DRIVELINE HALVES TO SEPARATE WHICH CAN CAUSE SERIOUS BODILY INJURY OR DEATH TO THE OPERATOR OR OTHERS.

SAFETY CHAINS - PULL TYPE

When towing implements on the highway, use safety chain supplied with Implement. This will control the implement in the event the hitch pin is lost.

After attaching the safety chain, make a trial run by driving the tractor to the right and to the left for a short distance to check safety chain adjustment. If necessary, readjust to eliminate tight or loose chain.

Turf Flex 08-01	Operation Section 4-3	R 12-13-95
© 2004 Alamo Group Inc.

OPERATION

Image 91

Contents Turf Flex To the OWNER/OPERATOR/DEALER Safety Training Makes the Difference Page Table of Contents Page Safety Section ¡LEA EL PeligroInstructivo Safety Safety Following rules Serious injury or death. SG-26 Safety With the windows closed. SGM-11 Stop Mowing if Passersby are Within 100 Yards Unless Wait a minute...Save a life See Your SERVIS-RHINO Dealer Parts Information12 3A 3536 Peligro QTY Level DescriptionSafety D103 Turf Flex 08/01 Safety Section 04-23-99 00763535 Turf Flex Name D102 Safety Federal Laws and Regulations Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Introduction Section Introduction Introduction Before Operating this Machine Assembly Section Dealer SET-UP Instructions AssemblySwivel and Lift ARM Attachment Wing Mower Attachment Hydraulic Cylinder AttachmentCaster Wheel Attachments Rear Mower Figure Caster Wheel Attachments Rear Mower 11 Model Caster Wheel Attachments Wing Mower FigureRear Mower Attachment Caster Wheel Attachments Wing Mower 11 Model FigureAxle Arms in Postion Assembly SMV Attachment Driveshaft AttachmentHydraulic Hose Attachment Spool ValveLeft Wing Driveline Right Wing Driveline Wing Driveshaft AttachmentRope Routing for Automatic Head Locks Assembly Page Operation Section Attaching Cutter to Tractor Tractor PreparationSafety Chains Pull Type Roller Adjustment Cutting Height AdjustmentDriveline Attachment to Tractor Cutting Speed Starting & Stopping MowerMowing Tips Before Operating or Transporting this Mower Driveline Length Check ProcedureSpecial Instructions for Rough Terrain Operations Transporting Cutter DEG CV Driveline Check ProceduresStreaking Problem Possible Cause RemedyFrayed Edges on Page Maintenance Section Lubrication Information MaintenanceCenter 4-WAY Gear BOX GearboxGauge Wheel Assemblies Swivel AssemblyBlade Spindle Lubrication CV Driveline Profile Lubrication Driveline LubricationWing Driveline Profile Lubrication Blade Removal Blade InstallationBlade Servicing Blade SharpeningBelt Adjustment Procedure All Models except Belt Installation 11 Model Belt Adjustment Procedure 11 ModelProper Torque for Fasteners StorageMaintenance Tool Turf Flex Maintenance Section 12-13-95 Page To the OWNER/OPERATOR/DEALER TURFFLEX-OMWPL-08/01