Servis-Rhino P/N 00763618C manual Driveshaft Attachment, Hydraulic Hose Attachment, Spool Valve

ASSEMBLY

ASSEMBLY

DRIVESHAFT ATTACHMENT

All drivelines are equipped with slide collars on end yokes. To attach to the shaft grab and pull the collar on the end of attaching yoke toward the opposite end of the driveline. Slide the yoke (with collar depressed) onto the shaft. Move the yoke back and forth until the collar clicks forward and locks yoke in place.

Install the Jackshaft (1) on the Front Gearbox and install Bearing (2) on the Drive End. Sandwich the Bearing between the Bearing Supports(3) & (7). Install the Pipe Spacers (4) and retain with 1/2" x 7" bolt (5)and locknut.

Figure 15		3
1	5	7

4

FIGURE15

2

6

HYDRAULIC HOSE ATTACHMENT

Remove the caps from the Hydraulic Manifold (6 Fig. 13) on the Main Frame. Hydraulic Hoses p/n 00763742 are used for the Wing Cylinders and p/n 00762693 is used for the Rear Cylinder. Hose p/n 00765738 attaches to the remote on the Tractor Hydraulics. On the Hose p/n 00765738 at the Tractor disconnect install Fitting p/n 02957691 (1/2 pipe thread x 1/4 J.I. C.).

3-SPOOL VALVE

Cap the two side ports of the Manifold & connect the wing Hoses to Hoses p/n 00765738 with the 1/4" male JIC x 1/4" NPT pipe fittings.

SMV ATTACHMENT

Remove top Bolt from the Divider Gearbox Cover and attach Mounting Bracket. Bolt SMV to Bracket

Turf Flex 08/01 Assembly Section 3-10 R 12-13-95

© 2004 Alamo Group Inc.