Servis-Rhino P/N 00763618C manual With the windows closed. SGM-11

Page 14
(SFM-2)
(SGM-10)

SAFETY

SAFETY

DANGER!

WARNING!

Replace bent or broken blade with new blades. NEVER ATTEMPT TO STRAIGHTEN OR WELD ON BLADES SINCE THIS WILL LIKELY CRACK OR OTHERWISE DAMAGE THE BLADE WITH SUBSE- QUENT FAILURE AND POSSIBLE SERIOUS INJURY FROM THROWN BLADES.

Do not let the Blades turn when the Mower Deck is raised for any reason, including clearance or for turning. Raising the Mower deck exposes the Cutting Blades which creates a potentially serious hazard and could cause serious injury or even death from objects thrown from the Blades. (SRM-7)

WARNING!

Do not mow with two machines in the same area except with Cab tractors

 

with the windows closed. (SGM-11)

DANGER!

Do not turn so sharp or lift mower so high to produce a severe

 

"knocking" of the Driveline which will cause accelerated wear and

 

breakage of drive train components and could result inpossible injury

 

from the separated Driveline sections. (SRM-4)

WARNING!

Use extreme care when lowering or unfolding the implement’s wings.

 

Make sure no bystanders are close by or underneath the wings. Allow

 

ample clearance around the implement when folding or unfolding the

 

wings. Use extreme caution around buildings or overhead power lines.

 

(S3PT-5)

DANGER!

This Implement is wider than the Tractor. Be careful when operating

 

or transporting this equipment to prevent the Implement from running

 

into or striking sign posts, guard rails, concrete abutments or other

 

solid objects. Such an impact could cause the Implement and Tractor

 

to pivot violently resulting in loss of steering control, serious injury, or

 

even death. Never allow the Implement to contact obstacles. (S3PT-12)

DANGER!

There are obvious and hidden potential hazards in the operation of this

 

Mower. REMEMBER! This machine is often operated in weeds and

 

in heavy grass. The Blades of this Mower can throw objects if shields

 

are not properly installed and maintained. Serious injury or even death

 

may occur unless care is taken to insure the safety of the operator,

 

bystanders, or passersby in the area. Do not operate this machine

 

with anyone in the immediate area. Stop mowing if anyone is within

 

100 yards of mower. (SFM-1)

DANGER! All Safety Shields, Guards and Safety devices including (but not limited to) - the Discharge Deflectors, Steel Guards, Gearbox Shields, Belt Shileds, and PTO Shields should be used and maintained in good working condi- tion. All safety devices should be inspected carefully at least daily for missing or broken components. Missing, broken, or worn items must be replaced at once to reduce the possibility of injury or death from thrown objects, entanglement, or blade contact.

Turf Flex 08/01

Safety Section 1-8

© 2004 Alamo Group Inc.

 

Image 14
Contents Turf Flex To the OWNER/OPERATOR/DEALER Safety Training Makes the Difference Page Table of Contents Page Safety Section Instructivo Peligro¡LEA EL Safety Safety Following rules Serious injury or death. SG-26 Safety With the windows closed. SGM-11 Stop Mowing if Passersby are Within 100 Yards Unless Wait a minute...Save a life Parts Information See Your SERVIS-RHINO Dealer12 3A 3536 QTY Level Description PeligroSafety D103 Turf Flex 08/01 Safety Section 04-23-99 00763535 Turf Flex Name D102 Safety Federal Laws and Regulations Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page Introduction Section Introduction Introduction Before Operating this Machine Assembly Section Assembly Dealer SET-UP InstructionsSwivel and Lift ARM Attachment Hydraulic Cylinder Attachment Wing Mower AttachmentCaster Wheel Attachments Rear Mower Figure Caster Wheel Attachments Wing Mower Figure Caster Wheel Attachments Rear Mower 11 ModelCaster Wheel Attachments Wing Mower 11 Model Figure Rear Mower AttachmentAxle Arms in Postion Assembly Spool Valve Driveshaft AttachmentHydraulic Hose Attachment SMV AttachmentWing Driveshaft Attachment Left Wing Driveline Right Wing DrivelineRope Routing for Automatic Head Locks Assembly Page Operation Section Tractor Preparation Attaching Cutter to TractorSafety Chains Pull Type Driveline Attachment to Tractor Cutting Height AdjustmentRoller Adjustment Mowing Tips Starting & Stopping MowerCutting Speed Driveline Length Check Procedure Before Operating or Transporting this MowerSpecial Instructions for Rough Terrain Operations Transporting Cutter CV Driveline Check Procedures DEGProblem Possible Cause Remedy StreakingFrayed Edges on Page Maintenance Section Maintenance Lubrication InformationGearbox Center 4-WAY Gear BOXBlade Spindle Lubrication Swivel AssemblyGauge Wheel Assemblies Wing Driveline Profile Lubrication Driveline LubricationCV Driveline Profile Lubrication Blade Sharpening Blade InstallationBlade Servicing Blade RemovalBelt Adjustment Procedure All Models except Belt Adjustment Procedure 11 Model Belt Installation 11 ModelStorage Proper Torque for FastenersMaintenance Tool Turf Flex Maintenance Section 12-13-95 Page To the OWNER/OPERATOR/DEALER TURFFLEX-OMWPL-08/01