Generac Power Systems 005012-1 Lifting the Generator, Specifications, Fuel Consumption

Page 9

Section 1 — General Information

40kW Liquid-cooled Generators

1.9LIFTING THE GENERATOR

When lifting or hoisting equipment is used, be careful not to touch overhead power lines. The generators weight of more than 900 pounds requires proper tools, equipment, and qualified personnel to be used in all phases of handling and unpacking.

1.10 SPECIFICATIONS

‹ 1.10.1 GENERATOR SPECIFICATIONS

 

 

Single-phase

 

Model

005012-1

 

 

Rated Max. Cont.

37 (NG), 40 (LP)

 

AC Power Output (kW)

 

 

 

Rated voltage (volts)

120/240

 

 

No. of Rotor Poles

4

 

 

Driven Speed of Rotor

1800

 

 

Rotor Excitation System

Direct excited brush type

 

 

Type of Stator

4 Wire

 

 

Rotor/Stator Insulation

Class F/H

1.11 FUEL CONSUMPTION

Natural Gas

 

% of Load

25%

50%

75%

100%

 

m3/hr

4.1

7.7

11.0

14.2

 

ft3/hr

143.1

271.1

388.5

502.0

LP Vapor

 

 

 

 

 

% of Load

25%

50%

75%

100%

 

m3/hr

1.7

3.3

4.7

6.0

 

ft3/hr

60.7

115.0

164.9

213.0

 

 

 

NOTE:

 

 

Fuel consumption is given at rated maximum continuous power output when using natural gas rated at 1000 Btu per cubic foot. LP gas is rated at 2520 Btu per cubic foot. Actual fuel consumption obtained may vary depending on such variables as applied load, ambient temperature, engine condi- tions and other environmental factors.

Fuel pressure for a natural gas set up should be five inches to 14 inches of water column (0.18 to 0.5 psi) at all load ranges.

Fuel pressure for an LP vapor set up should be 11 inches to 14 inches of water column (0.4 to 0.5 psi) at all load ranges.

‹ 1.10.2 ENGINE SPECIFICATIONS

Make

Chrysler

Displacement

3.9 liters

Cylinder Arrangement

V-6

Valve Arrangement

Overhead Valve

Firing Order

1-6-5-4-3-2

Number of Main Bearings

4

Compression Ratio

9.1 to 1

No. of Teeth on Flywheel

164

Ignition Timing at 1800 rpm

30 degrees BTDC

Spark Plug Gap

1.01mm (0.040 in.)

Recommended Spark Plugs

 

Champion

RC12LC4

Oil Pressure

30-80 psi

Crankcase Oil Capacity

4.0 U.S. quarts (3.8 liters)

Recommended Engine Oil

SAE 15W-40

Type of Cooling System

Pressurized, closed recovery

Cooling Fan

Pusher Type

Cooling System Capacity

5.0 U.S. gallons (19.3 liters)

Recommended Coolant

Use a 50-50 mixture of

ethylene glycol base and de-ionized water.

1.12RECONFIGURING THE FUEL SYSTEM

NOTE:

All models are configured for natural gas from the factory.

To reconfigure the fuel system from NG to LP vapor, follow these steps:

1.Turn the main gas supply off.

2.Remove the carburetor fuel hose from the outlet port (Port 1) of the demand regulator (Figure 1.8).

Figure 1.8 — Reconfigure the Fuel System

 

Port 1

 

Port 2

 

FUEL HOSE

FUEL HOSE

 

PLUG

BRASS HOSE

BRASS HOSE

PLUG

FITTING

FITTING

 

 

 

OUT

OUT

 

 

PORT 1

PORT 2

 

 

HOUSING

HOUSING

 

 

PORTS

PORTS

 

 

 

 

NG FUEL SYSTEM

LP FUEL SYSTEM

7

Page 8 Page 10
Image 9
Page 8 Page 10
Contents Liquid-cooled, Prepackaged Standby Generators ‹ Operation and Maintenance Authorized Service Dealer Location‹ HOW to Obtain Service IntroductionTable of Contents  Warning   Electrical Hazards  Generator Transfer SwitchAutomatic System Operation Generator AC Connection Systems‹ 1.7.2 High Coolant Temperature Switch ‹ 1.7.1 LOW OIL Pressure SwitchGenerator Fuel System Engine Protective DevicesUnpacking Reconfiguring the Fuel System SpecificationsLifting the Generator Fuel ConsumptionBefore Installation Torque SpecificationsStandby Generator Installation Coolant RecommendationsGenerator Mounting Support Generator Location‹ 2.1.1 Nfpa Standards ‹ 2.1.2 Other Published StandardsTotal Circuit Isolation Method Basic Standby Electric SystemEmergency Circuit Isolation Method Grounding the GeneratorTransfer Switch Signal Connections Battery InstallationGenerator AC Neutral Connections Preparation Before START-UP ‹ 3.2.1 AUTO/OFF/MANUAL Switch Using AN Engineered GTS Transfer Switch‹ 3.2.2 Fault Indicator LED Control Console Components‹ 3.2.5 SET Exercise Time Switch Engine Governor AdjustmentsManual Transfer START-UP ‹ 3.2.6 System Ready LEDRetransfer and Shutdown Automatic OperationWeekly Exercise Cycle Overload Protection for Engine DC Electrical System Checking Fluid LevelsCooling System ‹ 4.5.1 Check Engine OIL Level ‹ 4.5.2 Check Battery‹ 4.5.3 Exercise System ‹ 4.5.4 Inspect Cooling System‹ 4.5.11 Changing the Engine AIR Cleaner Miscellaneous Maintenance‹ 4.6.1 Cleaning the Generator ‹ 4.5.13 Coolant Change‹ 4.6.4 Battery Replacement ‹ 4.6.3 Battery MaintenanceService Maintenance Interval Information Scheduled MaintenanceLevel Maintenance Level Problem Cause Correction Troubleshooting PointsElectrical Data Electrical Data Electrical Data Electrical Data Engine Block Hold Down Battery Assy WireBOOT, Contactor Cables Battery Post Covwer BlackDetail Duct Intake MID AL Assy Wire 14AWG 7.5 #0 GRN/YELDuct Discharge RH AL Duct Discharge LH ALPage Control BOX HSB Assy 2A 12V UL BatteryDecal AVR Cover Cover Front Panel HSBComes with Engine Assembly Resistor Cover Flywheel Access CountersunkFlexplate 3.9L HSB Plug STD Pipe 3/8To a 17 Radiator Copper Brass Tank Coolant RecoveryVENTURI,3.9L Cryslr HSB 22FAN Radiator Support L/H SideTo Engine Hold Down AIR Cleaner Base AIR Cleaner PlatePlate AIR Cleaner TOP Flange Fuel InletLocktight Rotor 390 20KW 1P Direct HSB 2.5L Ford Rotor 390 15KW 1P Direct HSB 2.5L FordRotor 390 25KW 1P Direct HSB 2.5L Ford Rotor 39030AD1 HSB TecumExhaust Flange 2 Pipe NUT TOP Lock FL M12-1.75Washer Lock M12 Exhaust Blanket 800MMInstallation Diagram 40kW Liquid-cooled Generators 40kW Liquid-cooled Generators This Warranty Shall not Apply to the Following

005012-1 specifications

Generac Power Systems 005012-1 is a high-performance generator designed to provide reliable backup power for homes and businesses. Known for its innovative features and advanced technology, this generator is engineered to ensure consistent performance during power outages.

At the heart of the 005012-1 is its robust engine. With a Generac 999cc V-Twin OHV engine, it delivers impressive power output and durability. This engine is designed to run efficiently, making the generator an optimal choice for extended use during outages. The Quiet Test feature allows the generator to run at a lower volume during self-diagnostic tests, ensuring minimal disturbance to its surroundings.

One of the standout features of the 005012-1 is its ability to automatically detect power loss and start up within seconds. This automatic transfer switch ensures that when the primary power source fails, the generator takes over seamlessly, keeping essential appliances and systems operational. This rapid response time is crucial for maintaining comfort and safety during outages.

The generator is equipped with a user-friendly control panel that includes an LCD display. This panel provides real-time information about power usage, operational status, and maintenance reminders, enabling users to stay informed and address any issues promptly. Additionally, the model offers flexible monitoring options through mobile connectivity, allowing users to check the generator's status remotely via smartphone or other devices.

Designed for longevity, the 005012-1 features a durable aluminum enclosure that protects the generator from the elements, ensuring reliable operation in various conditions. Its compact design allows for easy installation and integration into existing power systems without occupying excessive space.

Fuel efficiency is another hallmark of the 005012-1, as it operates on propane or natural gas, providing flexibility in fuel choice. This versatility not only aids in reducing operational costs but also appeals to environmentally conscious users seeking cleaner energy solutions.

Overall, Generac Power Systems 005012-1 stands out as a dependable and technologically advanced generator, combining power, efficiency, and user-friendly features. Its commitment to reliability makes it a top choice for those looking to safeguard their homes and businesses against unexpected power interruptions.
Top Page Image Contents