Bush Hog HM2008 Preparation For Use, Do the following before coupling the machine to the tractor

Page 21

①

Preparation For Use

The photo shows a fully assembled machine. For shipping,the machine has been partly disman- tled - reassembling is carried out according to the assembly instructions later in this manual.

Do the following before coupling the machine to the tractor:

(A)Check that the stabilizer is equipped with the correct spring. The color of the spring must be as shown.

Model	Color
HM2007	Green
HM2008	Green
HM2009	Black

(B)Check that the machine is equipped with the correct connecting link, and that the stabilizer is fitted in the correct hole.

NOTICE

If the above are not connected correctly the machine will not be able to work properly.

(C)Lubricate the sliding surface of the lifting bracket with lithium grease or equivalent.

(D)Lubricate the carrying tube of the swing bar with lithium grease or equivalent. The lubrication is easier to carry out by first removing the front support leg from the right hand hitch lug. The three point lift hitch may then be moved slightly forward and swung down and forward. After this the hitch can be turned to the left, so that the carrying

tube can be lubricated at full length.

19

Image 21

Contents Bush HOG Congratulations HAY Mower Bush HOG Dealer Preparation Check List Safety Signs Signal Words Safety Alert SymbolImportant Safety Precautions This Act Seeks Osha RegulationsChild Labor Under 16 Years Old Models HM2007 HM2008 HM2009 Generally about supplementary equipment Model HM2007 Model HM2008 Model HM2009Machine Identification Kg / lb General Safety Instructions SafetyPage Page Model Kg lb HM2007 415 HM2008 440 HM2009 465 Safety instructions during crane lift Page New Machine be careful HM2009 Preparation For Use Do the following before coupling the machine to the tractorModel Color Clip Pin Pawl Remove Clip Pin and Rotate Pawl Fitting of the suspension Mounting couplingMin mm PTO shaft Shortening of the shaftChecking of PTO shaft length Model HM2007 13mm 1/2 Model HM2008 11mm 7/16Model HM2009 8 mm 5/16 Stabilizer Height of the suspensionLifting height If the distance C is too big, raise the lift arm at DPage Transport Unhitching TransportUnhitching 80 ± 95 ± 60 ft./lbs 70 ft./lbs Maintenance Operate with safety note the followingKnives cutting discs Hole In Front Belt Guard Lubrication generally BeltsOil Filler Plug Oil cutterbar Oil bevel gearboxOil level Plug D Swath Roller Optional equipment Right-hand & Left-hand swath rollersRight-hand & Left-hand swath boards Hillside Kit As Seen From Below Optional high skid Optional hillside kitFlat Blades Special flat knives Throwing wingsLeft cone 2.8 mm Directions for repair Important, when fitting the gear to the machineHydraulic lifting cylinder Bevel gearboxPage Collar bearings illustration CutterbarFixing of collar bearing ilustration Synchronizing illustrationProblem Possible Cause Correction Problem/Fault Analysis and CorrectionsWinter storage Conversion Chart LubricantsTorque Value Assembly Instructions Support Leg U Bracket 16-40 mmTwisted Strut 12 40 mm Plow Bolt 12 35mm Plow BoltModel HM2009 Model HM2008 Model HM2007 59 ft./lbs Gearbox Working Direction GearboxWorking Direction 10 35 mm 10 30 mm 10 30 mm 30 -10.5 3 mm 10 -30 mm 30 10.5 3 mm Optional Equipment Safety Decals Page Page Bush HOG