Bush Hog HM2009, HM2008, HM2007 manual 59 ft./lbs

Page 53

14.Remove bolts from hubs to allow installation of blade cutting discs. (Figure 10) Refer to illustration on next page for correct positioning of blade cutting discs. Pay particular attention to blade rotation and arrange discs at 90° to each other. NOTE: The end discs (outer end only on 7’ model) use longer bolts to also hold the cones in place and the nut guards on the cone discs are “cut out” for clearance. A snap-in plas- tic cap is provided for each cone.

Figure 10

Green - NOTE: Only used with flat blade kit

Cutting Disc Offset

HM2009

HM2007

Note the correct mounting of the cutting disc which is to be 3 mm offset.

(59 ft./lbs.)

Always use LOCKTITE 242 on the bolts of the cutting discs.

Models HM2007, HM2008, HM2009	Models HM2008, HM2009
(Outside Crop Divider)	(Inside Crop Divider)

51

Image 53

Contents Bush HOG Congratulations HAY Mower Bush HOG Dealer Preparation Check List Safety Signs Signal Words Safety Alert SymbolImportant Safety Precautions Child Labor Under 16 Years Old This Act SeeksOsha Regulations Models HM2007 HM2008 HM2009 Generally about supplementary equipment Model HM2007 Model HM2008 Model HM2009Machine Identification Kg / lb General Safety Instructions SafetyPage Page Model Kg lb HM2007 415 HM2008 440 HM2009 465 Safety instructions during crane lift Page New Machine be careful HM2009 Model Color Preparation For UseDo the following before coupling the machine to the tractor Clip Pin Pawl Remove Clip Pin and Rotate Pawl Fitting of the suspension Mounting couplingMin mm Checking of PTO shaft length PTO shaftShortening of the shaft Model HM2009 8 mm 5/16 Model HM2007 13mm 1/2Model HM2008 11mm 7/16 Stabilizer Height of the suspensionLifting height If the distance C is too big, raise the lift arm at DPage Unhitching Transport UnhitchingTransport 80 ± 95 ± 60 ft./lbs 70 ft./lbs Knives cutting discs MaintenanceOperate with safety note the following Hole In Front Belt Guard Lubrication generally BeltsOil Filler Plug Oil level Plug D Oil cutterbarOil bevel gearbox Swath Roller Right-hand & Left-hand swath boards Optional equipmentRight-hand & Left-hand swath rollers Hillside Kit As Seen From Below Optional high skid Optional hillside kitFlat Blades Left cone Special flat knivesThrowing wings 2.8 mm Directions for repair Important, when fitting the gear to the machineHydraulic lifting cylinder Bevel gearboxPage Collar bearings illustration CutterbarFixing of collar bearing ilustration Synchronizing illustrationProblem Possible Cause Correction Problem/Fault Analysis and CorrectionsWinter storage Torque Value Conversion ChartLubricants Assembly Instructions Support Leg U Bracket 16-40 mmTwisted Strut 12 40 mm Plow Bolt 12 35mm Plow BoltModel HM2009 Model HM2008 Model HM2007 59 ft./lbs Working Direction GearboxWorking Direction Gearbox 10 35 mm 10 30 mm 10 30 mm 30 -10.5 3 mm 10 -30 mm 30 10.5 3 mm Optional Equipment Safety Decals Page Page Bush HOG