Bush Hog HM2008, HM2007, HM2009 manual Belts, Lubrication generally

Page 33

①- ②

③

V-belts

The spring is to be tightened so that the end of the spring is in alignment with the edge of the bracket, as shown.

Models HM2007 - HM2008 - HM2009 (D) = 0 mm

New V-belts should be re-tightened after a few hours operation. Inspection of V-belts is carried out through hole (E). The front part of the belt guard can easily be removed.

Lubrication (Lubricants, - see page 46)

Before starting to use a new machine: Check the oil level of the gearbox and the cutterbar and lubricate the machine and driveline. See pages 32 & 33 and observe all lubrication decals.

Lubrication generally

Every

10th

hour

Every

 

(daily)

40th

hour

 

Number

of

nipples

 

 

*

 

 

 

 

5

Driveline with overrun clutch

 

 

(A)

●

●

 

 

 

 

 

 

 

 

 

 

 

 

 

(B)

● ●

 

2

Swivel link (twice daily)

 

 

 

 

 

 

 

 

 

 

 

(C)

● ●

 

 

All movable parts should be lubricated with oil or grease once-twice/daily -

 

 

 

 

 

be especially attentive to the sliding surfaces shown.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

*

All universal crosses and bearings in the plastic tubes of the PTO shaft are to be lubricated every 8

-10 hours of operation. Profile tubes should be separated, cleaned and lubricated after 40 hours use. Use lithium grease.

NOTICE

Regularly check the driveline. Any damage or lack of lubrication to the hollow shaft may cause the PTO shaft on the tractor or machine to be damaged beyond repair.

During still periods (one week or more): Wash and lubricate the machine, spray it with a thin layer of rust protecting oil - especially important at cutting discs.

The hydraulic lifting cylinder of the machine: During prolonged storage press the piston rod into the piston housing (remove the complete lifting cylinder at the connection link on the gearbox), or coat the exposed surface of piston rod with grease.

31

Page 32 Page 34
Image 33
Page 32 Page 34
Contents Bush HOG Congratulations HAY Mower Bush HOG Dealer Preparation Check List Safety Signs Signal Words Safety Alert SymbolImportant Safety Precautions This Act Seeks Osha RegulationsChild Labor Under 16 Years Old Models HM2007 HM2008 HM2009 Generally about supplementary equipment Model HM2007 Model HM2008 Model HM2009Machine Identification Kg / lb General Safety Instructions SafetyPage Page Model Kg lb HM2007 415 HM2008 440 HM2009 465 Safety instructions during crane lift Page New Machine be careful HM2009 Preparation For Use Do the following before coupling the machine to the tractorModel Color Clip Pin Pawl Remove Clip Pin and Rotate Pawl Fitting of the suspension Mounting couplingMin mm PTO shaft Shortening of the shaftChecking of PTO shaft length Model HM2007 13mm 1/2 Model HM2008 11mm 7/16Model HM2009 8 mm 5/16 Stabilizer Height of the suspensionLifting height If the distance C is too big, raise the lift arm at DPage Transport Unhitching TransportUnhitching 80 ± 95 ± 60 ft./lbs 70 ft./lbs Maintenance Operate with safety note the followingKnives cutting discs Hole In Front Belt Guard Lubrication generally BeltsOil Filler Plug Oil cutterbar Oil bevel gearboxOil level Plug D Swath Roller Optional equipment Right-hand & Left-hand swath rollersRight-hand & Left-hand swath boards Hillside Kit As Seen From Below Optional high skid Optional hillside kitFlat Blades Special flat knives Throwing wingsLeft cone 2.8 mm Directions for repair Important, when fitting the gear to the machineHydraulic lifting cylinder Bevel gearboxPage Collar bearings illustration CutterbarFixing of collar bearing ilustration Synchronizing illustrationProblem Possible Cause Correction Problem/Fault Analysis and CorrectionsWinter storage Conversion Chart LubricantsTorque Value Assembly Instructions Support Leg U Bracket 16-40 mmTwisted Strut 12 40 mm Plow Bolt 12 35mm Plow BoltModel HM2009 Model HM2008 Model HM2007 59 ft./lbs Gearbox Working Direction GearboxWorking Direction 10 35 mm 10 30 mm 10 30 mm 30 -10.5 3 mm 10 -30 mm 30 10.5 3 mm Optional Equipment Safety Decals Page Page Bush HOG
Top Page Image Contents